plastic windows instantly liked to consumers immediately after its launch.At present, almost no one sets their classic wooden counterparts.Their advantage in the fact that they can be installed not only a professional with experience.After reading this article, you will learn how to install plastic window.Let's get started.
Installation of double-glazed windows have the following nuances:
- You can install them even in winter.However, you yourself should understand that it is best to work in the warmer months.In addition, summer and spring foam cures better.So how to install plastic window need all the instructions, this process may take more than one day live in a windswept apartment will not be too comfortable.
- need for accurate measurement of window openings.From the removal of measures of success depends on the success of the event.
If you want a cheap plastic windows (alone) in the panel house, the measure should also be an internal opening.The fact is that in such cases the box frames to hold the opening cross section of which resembles the letter "D".Measurements were carried out according to the following instructions:
- measure the distance between the side slopes;
- measure the distance from the sill to the slope on both sides;
- note that the width of the window sill must be equal to the width of the wall, with the exception of the section width.
Before you properly install plastic window in a brick house, you should determine the load-bearing walls, since it is usually a thick layer of plaster.This should be taken into account by measuring the window openings.
believed that the easiest way to install double-glazed windows in a wooden house, but it is not.Note that a tree - a material moody, easily expands and contracts under the influence of environmental factors.And because you need to install windows on okosyachku.It is an independent structure made of timber, this door frame trim.Thanks to the windows are not jammed and do not deform due to the "movements" of the tree.
Once again, as the right to install plastic window is difficult, it is necessary to carefully follow the instructions.
- Pulling the plug, pull themselves windows.
- mark each of them, so as not to confuse the installation.
- Remove the protective film from the ends, pasted in its place a paper tape or a similar cover.At the end of
- plastic frames glued vapor barrier film.
- established in the opening bearing pads, put them assembled box.
- carefully adjust it using the building level.
- finally lock box with metal profiles and fill in the blanks with foam quality.
- Install Window sills, and then carry out installation of double-glazed windows.Attach plugs need to start from the top.
- establish internal slopes, fasten cover profile.
If you are sure you observe all our instructions, then install new windows (Moscow strike any of their range) can quickly and accurately.We wish you success!
