bevel gear - so the mechanism that connects to the motor and the driven machine.His body arranged gears fixed on the stationary shaft.
bevel gear used for the transmission shaft for one another to increase the torque.It is generally at a right angle.
parts of his body exposed to the forces of the machine, which carries out the work.That is why in its manufacture using steel and cast iron.Rarely used light alloys.Details are in complex form - is determined by the way the components of the assembly are arranged relative to each other.Brackets, flanges and caps are attached to the body parts.
bevel gear has a whole mass of advantages.The upper part of its cover, for example, have a horizontally disposed surface, so as to use them as process database.The base body of the part is smooth, the legs of high strength and insulated.Their shelf life is very long, since the amount of oil is large enough.Vibroakustichesky improved properties of the part - is due to the fact that the cap housing is very malleable, and the base - hard.They are smaller warp aging, because of what is happening and no oil leak.And one more thing - Cone has a lightweight outer treatment.This is also an important factor functional mechanism.
It should also touch on the topic regarding how going to bevel gear.
before assembly inside the cavity is thoroughly cleaned and covered with oil resistant paint.Then, the drive shaft is pushed mazeuderzhivayuschee ring and the shaft - bearing.Then put on the glass and spacer, and then - the second bearing.You also need to install Multiwing washer and nut.Then, in the driven shaft is necessary to lay the key, and then set the spacer and bearings.The collected trees are stacked at the base of the gear housing, put a cover on it, which must be pre-coated with an alcohol varnish.The next step is to put in the camera bearing grease and put the bearing caps and metal pads to adjust.Then you need to install the cover, and then perform a check rotation shaft and make sure the bearings are not jammed.All is fixed with screws.Following screwed oil drain plug.Then you need to pour oil into the control and screw cap.So going to the conical-stage gearbox.
So familiar with the build process, with a destination too.Finally, we note some positive qualities of a bevel gear.This quiet, compact, durable, reliable and trouble-free operation - even when the revs are too high.
Reducer can be vertical or horizontal - depending on the need.Bevel wheels (applies to single-stage gear) is almost always performed with curvilinear tooth profile.This is justified by the fact that the first stage assumes great linear and angular speed.
