Do you have a favorite car, and you want to make it even more attractive toned glass?Do you think this is a very difficult and you can not cope without a master?After reading this article, you will realize that the big mistakes and find an answer to the question "how to glue shading?"
Every driver loves his car, he cares about her, cleans, washes and adorns.Toning, until recently, was an indispensable accessory of most cars.Color and bandwidth toned glass, before the recent amendments to the SDA, was a personal matter for each motorist.Changes to the set of rules of the road changes today govern allowable blackout.According to the new decree, the capacity of the windscreen must be at least 75%, review the side windows - at least 70%.Violation of these regulations leads to an administrative penalty.It must be remembered.
How glue tinted
If you do decide to, you should not buy cheap film: it is excessively thin and complete, you will not find a special knife and spatula, which would have to be purchased separately.For gluing for future dry rag, glass cleaner and a siphon, which is poured into the same glass cleaner.
Now that prepared everything necessary, you can start the process of toning.Work should be done in a warm room, and preferably with the assistant.If the sticking film will take place on the street, it is recommended to carry out all actions in windless weather at temperatures below + 20 ° C does not.Glass, wash containing alcohol.It cleans and degreases the surface.After the glass is dry, applied tinting film.Here we must be careful not to be cut along the contour of a strictly material.The entire perimeter necessarily need to leave 3-4 cm allowances.
Corner poddevat film gently and separated from the substrate.This siphon sprayed diluted solution to the dark side, to avoid bonding.The separated dark layer is applied to the glass and carefully smoothed using a plastic spatula.The direction of motion of the trowel must be from the center towards the periphery.At times, the film should be wiped with a damp cloth.Extra protruding edges are cut with a sharp knife, which should have been included.Just toned and side windows.
Now we have to figure out how to glue the tint on the rear window.Not all drivers can correctly position the film without removing it from the machine.On cars VAZ cord is removed, and the glass is squeezed out.Since work uncomfortable (due to its convex shape), the procedure is divided into two stages.Glass imaginary line is divided into two parts.For one half of the applied film.It was cut with the same margins as the side windows (2-3cm).If formed folds need building hairdryer.They film is heated and stretched until until no wrinkles.The second part should be glued only butt and nothing else.Upon completion, the glass is set in place.
It has become fashionable to tune not only glass, but headlights and taillights.Such tinting headlights - a laborious process and also completely useless.Indeed, over time the edges of the film will begin to flake off and blow all the works to naught.Also applied vinyl on the hood, trunk and fenders of the car that makes your car not only beautiful, but also original.
We figured out how to glue tint.This is no big deal.We just need a little patience and a sharp knife.However, do not overdo it with dimming.It is best to glue the film only on the rear windows.Remember, for violation of the PDP in the tinted glass is a penalty in the amount of 500 rubles, and from 1.07.2012 year - perhaps stay.
Information!The size of the fine does not depend on how many glasses darkened applied coating light transmission and what is the "native" windows machines.So decide for yourself whether you need to know how to glue tint.
