How to connect a car?

Radio - a device that combines a tape recorder and radio.Most drivers do not pose a trip in a car without music.It helps pass the long hours on the road.Always maintain a certain state of cheerfulness, so you need a driver.With it you can collect all of any works and enjoy them on the trip.Car allows you to create the effect of presence, there is no feeling of loneliness.At the same time, you can always turn off the music.

Therefore, the question of how to connect the car, of interest to many motorists.First of all, you have to be confident in their abilities.Independently connect it to the car any person.

Firstly, there is the radio to any instruction.Often it is not just included in the package and glued directly to the top cover of the device.

Secondly, in modern cars uses standard connectors for connection that you just have to connect with each other.

If the strange lines in the instructions are in doubt, and there is no standard connectors, here is a small guide on how to connect the car.

First of all, the installation process affects the type of device.There are single-block that is composed of one piece of car and diblock respectively from the two parts.When you purchase it is necessary to see whether there is the possibility to install diblock device, there will be enough space on the panel board.Once the choice is made, it remains to solve the question of how to connect the car.

  1. If the chosen device is not highlighted the power cord, the best connection will be via a battery or cigarette lighter to the radio.
  2. Usually the power cord consists of yellow and red wires.Last executed simultaneously disable the radio and switching on the ignition.Yellow is used to configure the device.These postings have to be connected in parallel.If you have been scattered, and can leave the radio turned on, it is best to install a separate switch on the red wire.So just to avoid unexpected discharge of the battery.
  3. blue wire is responsible for the antenna.After connect the car, produced automatic transmission signal to the antenna and back.
  4. If you have not had the radio up to that time, most of all, the speakers are not connected.It is therefore necessary to carry out two-millimeter wire.
  5. now define the sound system.Suspension for speakers should be soft.It can be made of a rubberized fabric.The diffuser is desirable to make plastic.
  6. most optimal placement for the speakers - is behind the rear seats.So they will not interfere with driving and provide optimal acoustics.
  7. To fix the radio in the cabin, using special frame.They are usually sold complete with a radio.Please set the audio in the proper place.Then, with the help of metal bending petals fix the system.
  8. after the transition to how to connect the car.It must be inserted all the way until it clicks.This will mean that the tape recorder is installed.The main thing - do not forget that when you install it is necessary to remove the negative terminal of the battery.Otherwise, the device will not operate.
  9. In case you need to remove the device, you need to loosen the metal tabs and pull it out.

If this statement can not help you in how to install car, it is best to contact the service center.Qualified experts will solve this problem in an hour.It is better not to conduct experiments, connecting wiring, anyhow.After all, this way you can break down almost a new radio.