Probably all faced with a situation where you need to get something from the trunk or put into it, and the motor wound.The key to the luggage compartment, of course, in a bundle with the ignition key, so you have to turn off or the engine, or the intricate movements to remove it from the bundle.Today I want to tell you how to put the electric tailgate on your vehicle.
To do this, we disable the weight of the car and open the trunk.Withdrawn from the lock pistons, hooking a screwdriver, and then he clips.In the same way we are straightened with three, and remove the cover lock plastic.Use the key on 7 mm threaded sleeve is held, and the locking screw rod turns slotted screwdriver.When this is done, set the washer under the retaining screw and wrap it.Further, curved hook of wire rod, which is included, so that the spacing is 20 mm.After that, it should catch the locking screw, and the ear of the electric rails.
now necessary to fix the electric luggage compartment cover in the amplifier by means of two screws.He calmly fit in the plastic casing of the castle.
You can also install the electric door lock replaced by another similar car if he would be strong.To do this, turn away the head of all the nuts located on the mounting lock to the trunk, in an amount that provides design of your car, then it is removed.In his place we put analog.Because we do Wire rod and connect the lock lever and the drive for the luggage rack ear.Set it should be right near the lantern.
But be prepared for the fact that the stock of the electric power may not be enough, and if severe frosts, thickened grease and fall in voltage on-board power supply, the lid may not open.In this case, it is recommended to start the car and warm up the engine a little bit.During this time, the voltage is normalized, and electric trunk should work.If this does not happen, then it will need to warm up.
next step will be the power to the electric tailgate.To do this, lay the wires through the amplifier of the luggage cover so that they are parallel to the standard wiring harness.When you do that, you must bring them to the dashboard in the cabin.
further cuts button that will open the trunk.For example, it can be installed on the floor of the tunnel lining.They often have a plastic cap which must be removed.It will be a great place for your keys, although if desired it can be installed in another location.Note that it should not be fixed.Power must be supplied only when you hold it down.Otherwise, you can bring into disrepair electric.
connect the tips of the wires supplying power to your button and place it in a specific location of your choice.Now includes a lot and try to press the button.If you did everything correctly, the boot lid opens automatically when you press.
