If you are not strong in the Automechanika and do not know how to change the oil in the engine, without the help of automotive repair shops, then this article is for you.The process itself is not a big deal.To learn how to change the oil in the engine, you just follow a certain sequence.
first stage - preparation for work.Once you have bought motor oil, you need to find some canister to drain the waste liquid.Usually its amount depends on the type of engine (2.5-5 liters).We also need a new oil filter wrench and a few unnecessary rags.If possible get close to the oil filter or substitute container under the sump does not, then the oil should be changed on a viewing hole or overpass.
order to warm the oil in the crankcase, allow the engine a few minutes to idle, and then switch off the engine.After that, any mechanic who knows how to change the oil in the engine, find the drain plug.The latter is at the bottom of the pallet.Armed with cloth, unscrew the drain plug (most importantly - do not burn yourself) and substitute it by pre-harvested container.
Once the oil stops flowing, you must unscrew and get the old oil filter, drain the remaining amount of oil.If Okrut bolts are not obtained by means of a screwdriver, there is one proven way.You can pierce the filter tip screwdriver, and then use it as a lever.The rim of the new filter is required to lubricate with oil and set it in place old.During the filter change, the used oil is completely drained from the engine components, and then screw the cap back.How to change the oil in the engine?Unscrewing the oil filler cap, begin to fill in a new one.Upper level - roughly, without adding a half-liter.Replace the cap and start the engine again, that he worked for 30 seconds at idle, but not gazuyte!
Once oil passed through the thoroughfares of the engine, check the area around the drain plug for the presence of stains.Stop the engine and leave the car for a few minutes so that the oil "ustakanilos" and then add it to the level indicated on the dipstick.It remains to ride a few minutes and make a control measurement of level of oil, with not enough - add.
Now you know how to change the oil in the engine.After the procedure do not be lazy and write down the date and mileage produced by the procedure.You can also detach the canister label and stick it on the back of the hood, the next time to know what brand of oil was in the engine.To clean the components and mechanisms of the engine from wear products and wastes, using flushing oil.
How to replace oil in the engine together with the wash?Everything is very simple.Once will merge old, flushing and fill a couple of minutes again Start the car, and then drain the flushing.Important: The new filter before washing process is not established.Flushing oil is not recommended for use when the engine is completely "overgrown".Better to take a fresh engine, although it is more expensive, but the motor will clear better.
