Each of motorists knows firsthand what wrong the moment of ignition.For the driver, this constant problems with starting the engine, with the loss of power, as well as increased fuel consumption.For the very same unit such problems can end very badly, especially if the ignition timing is picked up a little earlier than it should be.
In this article we look at how to put the ignition on contact and contactless system.Start from the beginning of production is set to classical music, while the second came at the beginning of the twenty-first century.She immediately gained popularity among car owners, as different from the previous high reliability and service life, as well as the best electrical characteristics, which depends on the spark in the combustion chamber.
learn how to put on the car ignition, you can tell briefly.The process will be discussed below.The fact that four-stroke engines is quite picky about the time, but despite this, set the ignition at the same Soviet or foreign vehicle is not as hard as you put in the ignition Iz Jupiter 5. The latter for each cylinder, two of which, has its own, separate the contact ignition system, each of which require adjustment.
Now directly on the procedure itself.Of course, you can reach the nearest service station, where it is made using a stroboscope, but this costs money, and this product has not every car enthusiast, so we consider the simplest way, which requires a minimum of effort, tools and knowledge.
First of all, you need to calculate the compression stroke in the first cylinder.Fleece need to plug the spark plug hole, and then slowly rotate the crankshaft of the ratchet.Once she takes off, cranking on, until the alignment marks on the pulley and the front cover on the low tide.In some vehicles, there are three labels, each of which corresponds to the AI-80, AI-92 and AI-95 during the rotation.In fact, about how to put the ignition on a particular vehicle, there are many guides only need to spend some time searching online.
return to our procedure.Installation crankshaft label medium determines the ignition timing of 5 degrees.At that time, while the crankshaft is their "dovorachivat" in the combustion chamber will already occur inflammation.Each brand of gasoline at the time it is different, thus changing the angle and timing.
need to install plug can be renovated, as well as after the negligent use of the vehicle.Ignition can lose itself, if the motor generates a higher vibration.Then we'll re-ask the question: "How to set the ignition?".Vaz 2106 has the same system as described above, so it will be no problems.Now, when the piston is at top dead center, can be installed in a distributor position.
To do this, remove it from the drive, and then set the slider towards the external contact the contact of the first cylinder on the cover.Thus, at the end of the compression stroke in the first cylinder it will be fed the same spark that will ignite the mixture.Well, now the question is how to put the ignition should not occur.After completion of this procedure is to start the engine, after which the heated unit for a more precise adjustment.
