For some men, the car - the most favorite toy.Someone thinks his "iron horse", someone refers to him as a lover.But be that as it may, everyone wants that his car was not only the fastest but also the most beautiful, stylish, prestigious and cool.
«Bleed" the car in two ways.The first - is to replace its internal parts.However, this method requires long-term investment and the help of experts.And sometimes it turns out that to buy a new car will be cheaper.And the second way - is to change the appearance of "iron horse."The cost is cheaper, and you can handle yourself, if your hands are growing properly.Therefore, the question of how to glue the film carbon - one of the most talked about in the various thematic Internet resources.
In order to understand how to glue carboxylic film, follow the simple guidelines.Let's start:
1. Before stick carboxylic film, it is necessary to thoroughly clean the intended treatment site.To do this, the area is washed out sticking degreasing fluid.
2. Another point that should be considered before the glue film carbon - all is well and carefully measure.It is better to do it with his assistants.Attach the film (without removing the substrate) to the sticking place: rotate, mark.As they say, look before you leap - cut once.By this stage it is an expression suitable for all 100%.
3. Once you are marked out and measured out the necessary piece of film, it is necessary to remove the substrate.Do it again with the best assistants.It is important that the film is not glued to herself.
4. Next, spray the surface with soapy water as carboxylic stick tape from the first ideal is unlikely to succeed.Therefore a soap solution needed to be able to "fit" the situation of the film and to get rid of air bubbles from the carbon.An important point - to see to it that does not wet the very basis of the film, because there may be problems with its separation.
5. So, how to glue carboxylic film?The process itself is similar to the process of wallpapering.If you have this experience, then you can do it with film.Once you have made it to the car, it is necessary to uniformly prikatyvat squeegee while podsushivaya hairdryer and heating.You should begin from the middle to the edges.Make sure that no air bubbles are formed and irregularities.When such trouble can be neatly peeled off the tape and stick again, in the course of its heating hairdryer.If the film in places excesses or irregularities badly stuck, heating hairdryers, it can be harder to stretch and then smooth the surface.
6. Now all you need to leave for 15-20 minutes and dry hairdryer.So, you are very close to completing the process.How to glue carboxylic film, you already know.You're all nice finish.
7. After everything is dry, take a felt cushion and carefully walk across the film to completely expel soapy water and air bubbles.If, however, some of them will, do not worry.This can be solved by gently punctures the film with a needle and pushing the car.Or attach a damp cloth and warm hairdryer.In principle, small bubbles, prosohnuv, lost themselves in a few weeks.At the end of the whole process of cut and bend the excess film.
8. Now carefully once dry place sticking hairdryer.Then leave your favorite car for a day.This is to ensure that all finally "grab."In the morning once again inspect the entire surface and, if necessary, walk felt squeegee.
Keeping all of the above, you should have no problem with the way the glue carboxylic film.As a result, you will have a reason to be proud of themselves for at least two reasons.Firstly, the whole process you carried yourself.And secondly, you have given your beloved car a new, completely individual look.
