Installation of electric floor heating.
to install underfloor heating cable is necessary to comply with the following steps:
Step One. Click on the wall a suitable location for the thermostat, it is recommended to be installed at a distance of one and a half meters from the floor, as close as possible the area of installation.At the chosen location must be installed Electrical box.From the place of installation thermostat to the floor must be made in the wall of the vertical cutting grooves for placing a corrugated tube with a temperature sensor.
Step Two. Make a layout of floor heating.In preparing the plan must use the following formula for calculation of CC distance: Spacing (cm) = 100 * Area styling (sq.m) / cable length (m)
thoroughly prepare the floor surface prior to installation: clean the floor within the zone installation.Remove debris, dust, dirt and foreign objects.The surface must be clean and smooth.
Step Three. Lay the insulation and fix it.Insulation is an essential part of electric underfloor heating systems.Its absence can lead to large losses of heat.
Step Four. and secure the mounting tape.
Attach pieces of mounting tape to the floor using the tools (screws or dowels) in order to avoid any possibility of bias electric floor heating.
Step Five.Lay electric floor heating shape the heated area according to your plan.
All work on the installation and filling is made only in clean shoes with soft soles.This is necessary to prevent damage to the heating cable.
Lay floor heating evenly and without crossing over the entire area of installation.Respect the calculated step installation (tolerance not more than one centimeter in either direction).Undesirable location turns warm floor closer than 10 cm to each other.
Step Six. Pour the cement-sand screed. thickness of the concrete screed should be about five centimeters for systems with a capacity of up to 150 W / m2 or more.The consistency of the cement-sand mixture should ensure good contact with the surface of the floor heating and prevents the formation of air pockets.It is important.
After screed measure the resistance of floor heating and temperature sensor to confirm the absence of any fault.
Step Seven. Connect the thermostat to the ready-made system of electric floor heating.Set the temperature sensor.For such works best to consult a qualified electrician.
Step Eight. Lay the floor finish.
Step Nine. including ready electric floor heating system.Bask nazdorove.
For proper and competent installation is better to turn to specialists.
