Each owner of stationary or portable computer system should know how to connect to the computer a second hard drive.It would be a mistake to think that it is necessary to understand the only service personnel and consultants in their respective stores.The need to understand how to connect a second hard drive to your computer, it may be almost any time.For example, many people familiar with the situation when the urgent need to copy the information from one hard drive to another, with or without modification of the internal bus adapters USB.One solution - to connect a second hard drive sata (about standards, we talk a little bit later) directly to a free port internal port.
Species
Depending on how you connect to the motherboard existing models of hard drives are divided into the IDE, SATA and USB-devices.Each of the abbreviations used to indicate the interface.The first two - domestic.IDE is an older standard, therefore, such a device requires a certain setup.To distinguish the new hard drive from the old interface is very simple - to connect to the main board had used a narrow flat ribbon cable (blue, red, orange color).But in the older models of a wide trail, mostly gray.
How to connect a second hard drive to your computer
Suppose that you need to connect to the motherboard IDE-device.It is obvious that there must be a corresponding connector.So, there are three loop connector.One of them, a distant, often highlighted in color (two black and one blue).It must be inserted into the slot of the board.An important point: the trail "on the contrary" can not be connected, as the connector is provided a key-ledge.
At any IDE-hard drive is required to present a group of jumpers allows you to set the operating mode of the device.This M (master), S (slave) and CS (cable select).Last intended only for loops with 80 cores (against similar wire 40).If a single loop is already connected hard drive, then the second connection is necessary to see what position the jumpers.So, when the mode is Master, the second should be set Slave.But if there is "extra" plume, then the question of how to connect a second hard drive to your computer, usually does not arise: the first is "hanging" one hard disk, and the second - the other.Modes selected webs can be arbitrary.Plans are always indicated on the body of the drive.Sometimes it may be necessary in the BIOS port.
new standard
On how to connect a second hard drive to a computer equipped with SATA-ports, no problem.To make life easier for users, developers have provided a standard way to connect "one hard drive - a trail."Thus, it is necessary only to connect the wire to the SATA-Winchester either side and a second side - corresponding to the open terminal on the board.Even budget decisions required to contain at least two ports.Key protrusion is provided here - connect the "opposite" impossible.The only thing you should pay attention - this restriction 1.5 and 3 GB on some hard drives, display bridges.It is necessary when you connect your new hard drive SATA 2.0 or 3.0 to the old motherboard SATA 1.0, which realized an old revision of the interface.Usually the motherboard will automatically detect the hard drive, without requiring user intervention.
Power
conduct electrical power from the unit in the IDE, and SATA-devices to perform a particular form, so it can not be connected incorrectly.
