considered quite challenging gluing ceiling moldings.Fitting angles and docked - that's the main problem.Just below is a description of how to make the angle of the ceiling moldings.
begin with a tool that we need to do.Suffice it miter box and a construction knife.As a rule, it is necessary to trim moldings for interior corners.At first glance, it seems that everything is easy, but when a brand new plinth turns into unnecessary pruning, you begin to realize that not everything is so simple.Let's understand how it's done.
How to cut the corner ceiling moldings?
the easiest and fastest option is remembered that the plinth is applied to the upper right corner, so that he was on his left.Keep your finger on the surface of the moldings, which will be glued to the ceiling.We put a plinth in the miter box.At the bottom of its wall surface must be strips that you stick to your fingers.Knife slice area, turning it 450 so that the end was looking to the left.Left-hand part of the baseboard is ready.Now make cuts right hand side, ie,that which is to the right from the inner corner.
How to make the corner ceiling moldings in this case?
Putting a corner of the bar, note that the surface to be glued to the ceiling part.Put the workpiece to miter box, holding it to the bottom surface of the wall, which will be glued to the ceiling.Cut Area 450, with the tip of the blade should be directed to the right.Cutting off both sides of the plinth, applying them to the inner corner to check the correctness and accuracy of cuts produced.
If the angle of the repaired areas smooth, then the baseboards intelligence, we do not see gaps.If the wall with errors, trimmed baseboards, and then pasted.
But there are outer corners.How to make the corner ceiling moldings in this case?Let's look at this variant.Though cut skirting the outer corners of buildings accounts for much less than the inside, but still it must be done correctly.Note that if you have learned well how to join corners of ceiling moldings with an internal angle, you and the outside will be no problems.This method is the opposite of the previous one.We note at the top of the baseboard corner.Also important fact that at the time of forming the outer corner on baguette should already be prepared and fitted the inner corner.It's clear.Prepare to trim the left from the outer corner of the plinth.
attach it to the wall, side note, glued to the ceiling.Put this part of the plinth in the miter box so that it is lying on its lower part.And pressed against the far wall of the device used.With a knife at an angle of 45 degrees to cut the bar.The tip of the knife at the same time have to look to the right.
Glue this piece angle.It is important that the short side of the article was not shorter wall angle.If you will be a little longer - not terrible.The same method of preparing a right-hand portion of the outer corner of the plinth.Controlling their dock and glue.Now that you know how to make the angle of ceiling moldings with internal and external part of it, look at another interesting option.
How to make rounded corners?There
unusual premises with unusual angles.Taking into account the curvature of the corner, cut into small pieces.Prune each on both sides using the miter box and at an angle.Glue them joint to joint.The initial segment of curvature is glued directly to the plinth on the one hand, and the end - to direct the plinth on the other.
