If you have family members smoke, then surely they are very often take plastic disposable lighters (they are more durable than matches, but nevertheless also once become unfit for further use).And frequently, when the gas is over, they throw them.However, the useful parts of Chinese art, if you decide to make a lighter bike with his hands.The motorcycle will be in length of 4 cm and a height of 2 cm and a width of 1 cm. We consider in more detail how to collect from the lighter ski.
Parts lighters as materials
So how to make the bike from a lighter, if you use the manual, check the following list of elements that make up the Lighter:
-
1 or 2 shtuki- nozzle protection;
-
2 pieces - the case for the wheel, the lever, silicon and springs;
-
one thing - the lever of the nozzle;
-
1 or 2 pieces - a nozzle (depending on the number of exhaust pipes);
-
2 pieces - spring for silicon;
-
2 pieces - the nozzle body;
-
2 pieces - silicon;
-
2 pieces - incendiary wheel;
-
1 piece - a porous filter, 2 pcs.- If with a lid.
How to make the bike from lighters: a necessary tool
Besides all of the above are also useful to the following materials and tools:
-
superglue;
-
double-sided tape;
-
gas burner or a working lighter;
-
awl.
How to make the bike from lighters: step by step instructions
Take housing for lever insert into the corresponding slots for the spring-loaded silicon wheel for silicon and silicon.The wheel should spin freely.The result was the front of the motorcycle.
Similarly, the rear of the bike is made.Insert the lever into the front of the nozzle (this seat).
nozzle wrap the double sided tape or superglue Spread and insert the nozzle body (it's tailpipe).
Exhaust pipes fix on the back of a motorcycle, just above the wheel.
front of the motorcycle, take it down and turn the wheel.Heat the awl over the fire and make it to the pin projecting upward hole.Put on a porous filter cover and insert into the hole, which was previously done.Put lid on another filter.Surplus cut filter, oplavte edge.Thus, there is now a motorcycle wheel.
the part of the steering wheel to the front of the bike and attach the nozzle protection, slightly clenched, secure.Slightly below fasten the second defense.
Connect the front and rear of the bike to strengthen their seat.If due to design features of housing that fails to do the pre-combine them oplaviv or smeared with glue.
When all these manipulations is very important to observe the accuracy and clarity of action, and even more so their sequence.As they say: "Seven times measure - cut once."
second way
There is a second method of how to make the bike from the lighters.At first alloy along the body (this is the main difference from the first method).
In this case, the seat (which acts as a lever of the nozzle) and heated over a fire and "soldered".Exhaust pipe made from a nozzle that fits tightly over the rear wheel into the housing.If the adhesive is not required.Motorcycle front of 2 lighters can be decorated with just one protection (for the nozzle).In addition, the motorcycle two lighters can be made more exclusive, expanding number hardened, lights ...
It is also important to be careful, especially when fused two cases, so as not to overheat the soldering tip, and so as not to spoil the lighter deform it.
So we looked at how to make motorcycles of lighters.Of course, you can optionally attach a designer much more different parts, but in this article we consider the general principle invented not so long ago one young amateurs of the modeling of the United States of America.Motorcycle
of lighters collected independently, will testify about your high-level skills that a careful design and respect.Also, this hack will be a good gift for any man.Even if no one in your household smokes, you can buy cheap at the store two lighters and assemble this simple but pretty interesting project.Dare to manufacture this model of motorcycle, be patient, and let you do it!
