Assign any pattern, moving in a wide and smooth rails, quite simply.Quite different is necessary to work in the manufacture of small products.How to perform a relief patterns spokes, such as mittens, scarves or socks?This article gives advice and tips for just such occasions.Consider the example of the technique of knitting mittens.
What are the most suitable relief patterns for knitting mittens?
Since the maximum web width is usually no more than 8-10 cm, can be quite difficult to choose the pattern.The most commonly used braids, weave with the change of the right and wrong groups and other patterns, which consist of repeats is not a very large number of loops.The simplest designs can also be used to perform all products, including finger.But as a rule, large relief patterns knitting needles only the upper side of mittens.Here in this article as an example of the weave of the braid to demonstrate the technology.Presented as a description and calculation loops.
Features of preparation to work with relief patterns
Technique mittens circle is not suitable in this case.The fact that vyvyazyvanie ornament above manner is not possible because of the design.Even a simple alternation of right and wrong loops will look wrong.And about nakida, braids, weaving, and other items and can not speak.Therefore, the most appropriate to make gloves with a side seam to be located on the outside.Most often in magazines presented relief patterns spokes schemes.Thanks to this double support to understand the technology more easily.So, before you start, read the diagram liked ornament.Then, using an ordinary exercise book in the box, the calculations of the loop according to the rapport.You can also pre-tie a small segment to learn how density changes during the transition from the gum to the main track.To both gloves are guaranteed to receive the same, keep the work directly from the two coils, each vyvyazyvaya separately.
Knit Mittens simple patterns of braid
consider in more detail how to perform relief patterns spokes on the example shown in photo 1 model.Follow the steps described below:
- Dial on the spokes of 40 loops plus 2 edge.
- Knit elastic fabric consisting of alternating 2 front and 2 backstitches.Typically, the height of this part of mittens covering the wrist is about 8-10 cm. Optionally it may be longer or shorter.
- then make the transition to the base web.Half loops (back mittens) will continue to be bred purl loops.And on the other (upper part) is situated ornament.It will be a continuation pattern gum.All even (purl) ranks performed on the image.
- knit 2 rows and do the offset.To do this, first remove the extra needle 2 facial loop pattern, knit 2 purl loops, follow shot 2 loops, and so on.. As a result of the drawing of the figure will fancy side.After
- of the back of a number proceed to the direct creation weaves braids.Like the previous series, remove the first 2 loops facial pattern, knit 2, and then follow shot with 2 loops.This happens crossing strands in a different direction.
- Based on the photos, keep a job to the desired length gloves are made with the rear side on the back of a finger.Finish the pattern can be by continuously combining facial strips into a circle or a triangle while keeping the loops on the sides.
Can I use other openwork relief patterns for mittens needles?
As you can see, the formulation of the inner side provides a smooth, smooth fabric.But it is not always carried out in a similar way this part.You can do here and relief patterns spokes.From the description and schemes are some models can be represented as a completely openwork fabric mittens in the absence of gum in the early work.It may be part of a pattern of elements, whereby the product at the wrist tight-fitting hand.By combining different elements (braids, openwork, gum), you can get the model to your liking, using the most successful as the yarn properties and color characteristics.
