Chainsaw - an essential attribute of the owners of many gardens and suburban areas along with benzokosilkami and trimmers.This unit allows you within minutes to turn overgrown bush into a work of art, and if necessary to prepare a few cubic meters of wood for the winter.However, over time a chainsaw requires not only topping the fuel and regular sharpening the chain, which often loses its properties.This process is complicated by the fact that the teeth of the chain have a very complex geometry.However, with the necessary knowledge and tools can restore the previous characteristics of the device practically at home.Well, let's look at how to sharpening the saw chain with your hands.
Tools
Please prepare a range of instruments with which we will do sharpening mechanism.To this work took place with minimal loss of time, you need to have the following tools:
- Files with bar-limiter.The diameter of this device is dependent upon the particular type of chain saws.Often, this value does not exceed 5.2 millimeters.
- template for sharpening teeth.
- flat file or special device for sharpening chain saws (this can be found in any shop of gardening equipment).
- Vices.Their presence is optional, but they can be used to significantly reduce operating time, and effort spent with them less.
So how is sharpening the saw chain with your hands?
First we need to remove it from the blade, then tighten the grip of the tire and apply the template to remove the device so that the arrow on it indicates the direction of movement of the chain.Next you need to pick up a round file and make a few movements of the cutting teeth.Efforts to sharpen relatively element should be directed straight ahead.The angle of sharpening chain saws should be about 45 degrees.In carrying out these tasks in any case not sharpen the mechanism in the reverse movement of a file, because you are such actions, on the contrary, only blunt tooth, then no master can not reset the property.
Sharpening the saw chain with their hands made the same way for each subsequent tooth.Repeat this operation until such time as the entire mechanism is not well cut.
After these steps, turn the tire on the one hundred and eighty degrees and sharpen the second half of the details.Next we need to cut off a restrictive teeth.This is done by using template.At this point a file to saw off a tooth to the required height.Application template in this case necessarily, especially since they are only in special sets for sharpening.However, after all the work you need to remember that the height of the sharpening can be unequal.So be very careful.It so happens that even with one wrong action becomes unusable completely the entire chain.
final stage
After all teeth sharpened, a mechanism is put back on the chainsaw.Everything at this stage the question "how is sharpening the saw chain with your hands" can be considered closed.
