subwoofer - the dream of many car owners.With this device you can infinitely enjoy tones of music and watch the envious eyes of other drivers.But after the purchase and installation of this unit do not relax, so how to properly install a subwoofer in the car - that's half the battle.To make it sound good, it must be properly adjusted.
Therefore, after the acquisition of the device almost all motorists are wondering "how to set the subwoofer in the car."The answer is you learn in today's article.
First of all, after you install this tool you need to reset all the settings of the head unit.Then, select the position of the LPF on the amplifier and filter for the channel to set the desired frequency (approximately 50-70 Hz).After that it is necessary to translate a filter for the front channel to HPF.The mechanism is located on the amplifier.Channel frequency must be not less than 70 and not more than 90 Hertz.
If you use the passive division, at this stage the question "how to set the subwoofer in the car" for you is complete.However, if you are using per-channel amplification, ahead of you to do a lot more work, because, in addition to the amplifier have to separately configure the speakers.In this case, set the channel to filter HPF and tune it to the frequency of 2500 Hz.
You must then adjust the sensitivity of the speakers.For this reset to zero frequency amplifier and the volume is maximized.Then, turn the sensitivity control upwards.If, after these settings you notice that the audio is distorted, decrease the value of the regulator.
After all this, check the quality of work.Ideally, the sound should come from the subwoofer without any distortion and interference.But even if the music is good, the question "how to set the subwoofer in the car" is not yet exhausted.Pay special attention to the time off the audio system.If at this time you will hear a strange sound in the form of crackling or clicks, you should know that the speakers have signal interference.To resolve this issue, check the location of the wiring of the entire system.Remember that you need to not only be able to properly configure the speakers and subwoofer properly installed in the car with their hands.If necessary, move the wires in the other place.If the back of the bass there, and this should not be, connect the device to the opposite amplifier.To do this, you have to turn 180 degrees phase adjuster which is located on the subwoofer enclosure.If you do not have this, simply change the wire connections between a speaker "+" and "-".Then you will have the impression that the music is not heard from behind, and from the middle of the cabin.No noise and distorted sound from the subwoofer will not be as high.
This adjustment of the speaker is finished.After performing these steps, you will no longer wonder "how to set the subwoofer in the car."
