Technique previous generation typically had a configuration consisting of a record player, tape recorder and amplifier and speakers.Each passport, which was attached to audio of the period, there was a clear diagram-drawing, which indicates the sequence of connecting the amplifier and speakers .
How to connect the amplifier to your computer?Yes snap!After all, any CD-ROM of previous years has a line output to connect power amplifier for the purpose of playing CDs.
Now the question is how to connect the amplifier, consider a slightly different aspect (because all modern computers, from desktop PCs to laptops, sound device has at least two-channel stereo, with the same standard level and impedance line output).
computer audio feature, virtually inaccessible to amateur analog systems of the past, is that inexpensive sound card is able to synthesize programmatically even quadraphonic effects, reverb, etc.It is for this reason that the computer sound card has up to seven output channels.
To answer the question of how to connect the amplifier, as well as be able to take full advantage of the sound card, you need to determine how much it is outputs.
The simplest case - the two channels.This is a normal stereo and is suitable with simple stereo speakers.If you have a four-channel sound card, you can use two stereo to get a quadraphonic effect.Five output - it is possible to connect the subwoofer.
Usually they are active, that is, with built-in power amplifiers.Only one subwoofer, because human ears can not distinguish the direction of the source of bass, stereo meaningless.
So, your sound card has, for example, five outs.You can bravely buy 5.1 acoustics, which means that you will be given equipment, consisting of six subjects: five speakers and a subwoofer.Now, before you close the question arises, how to connect the amplifier to your computer.
departs from each speaker cable with plug.And at the rear of the subwoofer outputs are for them - just five of them.If you buy a speaker system 4.1, then the subwoofer respectively, will be only 4 exits for plugs and the speaker will be issued by the seller as only four.
Connection does not matter, that is, any column can be connected to any output.But input wire should be carefully considered.At the same subwoofer on the rear wall has two inputs of different colors, typically red and white.At the subwoofer wire with a plug at one end and at the other - two.Moreover, one red, the other - white.Here you can not go wrong: the red plug is connected to the input of the red and white - the white.
Now, to those who do not know how to connect the amplifier raises the question correctly determine the subwoofer on the computer.After all, it's the need to insert a plug, which is crowned by a wire from the other end!Find this channel may be using the operating instructions of "smart machine".But most modern computers, this entry is located on the front side of the chassis.
There was one small thing - to place the remaining speakers in the corners of the room, hiding wires.How best to do this, tell the practice and personal taste.But the best effect is obtained when a symmetrical installation of the device equilateral.
modern audio system is usually designed for direct connection of active speakers, each equipped with its own power supply, the outputs of the sound card.
Sound is fully adjustable driver software sound card, built-in operating system and controls for quick and easy adjustment - from the program audio player, for example, WinAmp.
