If you want to paste the ceiling moldings, but how best to do not know you, then we suggest you familiarize yourself with the process.Many people think that nothing particularly difficult about this task is not, however, as soon as it comes to doing this work, immediately appears a lot of questions.Therefore, to make it as small as possible, we try to develop a theme as much as possible.
First of all, it would not hurt to find out what all this ceiling moldings and "what it eats."Actually, a more accurate and scientific name of this element of decor - fillet.Paste it between the walls and the ceiling, and then the connection between them zashpaklevyvayut and color.Designed fillet to hide small blemishes after wallpapering, and give the room a more finished appearance and simply decorate the ceiling.
And now proceed directly to the question of how to glue the ceiling moldings.First of all you need to know material consumption.To do this, measure the perimeter of the room and decide what the width of the fillet you want to see on your ceiling.But even knowing the area of the room, try to buy a plinth with a stock because it will have to be cut, and can inadvertently make mistakes.
Next you need to decide which of the two ways you are going to attach fillets: they can be glued directly to the wallpaper with glue, and you can use putty, before be pasted wallpaper.The first method is to glue ceiling moldings, a simple and easy in its execution because it allows you to make an imperfect joint when wallpapering, which eventually closed fillet.Secondly, gluing with glue fillet is much more convenient than using a putty.But there is of this method are also disadvantages: firstly, it is more expensive, and secondly, you have glue, putty and paint the baseboard so carefully that none of the solutions did not get to the wallpaper.Experts believe that the second method is to glue ceiling moldings, much better as a dirty job and takes place before wallpapering and quirk looks spectacular.But to choose, of course, you.
start gluing skirting boards must always be at the corner of the longest wall, and that's where some problems begin to arise: before quirk smear glue or putty and attach to the desired location, you must first cut the corner.It will need a hacksaw and miter box.For those who do not know: miter box - a special device in the form of a tray designed for cutting boards and planks different angle.If there is no, and you do not know how to glue the ceiling moldings in the corners, use an ordinary sheet of paper.His angle is 90 degrees, and since you will need to cut the edge at an angle of 45 degrees, just fold the sheet so that the fold line passed through his area, and the edges of paper exactly the same.So you get a benchmark that can be used to make precise cutting fillet.But even when cut off, do not rush immediately to stick better to once again attach the baseboard to the wall to make sure that there are no errors.And if there are, they can always be corrected.
Now that all the angles are adjusted, you can start gluing.If kleite on putty, remember that it must be sufficiently thick for its consistency, it ensures adhesion strength, therefore, is not one quirk fall on your head.Apply the adhesive mixture oiled skirting to the corner between the ceiling and the wall and push it well to the excess solution "squeezed out" outside.Then all the excess simply removed with a spatula and a brush dipped in water, and the joints after drying adhesive or gently zashpaklevyvayutsya or sealed with special silicone sealant.If this is not done, the fillet will look very messy and will only spoil the overall look of the room.Knowing how to glue the ceiling moldings, you can easily do it yourself, which will essentially save your family budget.
