without reinforcement construction is complete no foundation.It does not matter what type it is: a belt, or a columnar monolithic.And as the material foundation for even relatively simple private home requires a lot of (sometimes several hundred meters), there is a lot of questions.One of them is: "How to knit reinforcement for the foundation?"
It should be noted that this process is quite complicated and requires a lot of time.Knit reinforcement submerged in a shallow strip foundation not everyone will be able, as in the opening width of 40-50 cm to fit a grown man.For example, on the foundation for the house of small size required reinforcement of 500-600 meters and is more than a hundred whips.The fourth part of this amount will be cut into bars of smaller length, which will create a three-dimensional structure.
Now we can talk about how to knit reinforcement for the foundation.If we talk about the strip foundation, it is quite simple.Each right angle between the bars prihvatyvayut wire and then twisted it.Where rods are lapped at least half a meter, it is required to knit in three places - in the center and on the edges.For breeding use wire with a diameter of 1-2 mm.It does not assume any support function, a thicker wire would be difficult to twist.From the valve to the outside of the structure is necessary to observe a distance of 2-3 cm.You can buy a special holder for the valve, then the distance will be observed by itself.Considering how the knit reinforcement for the foundation, it is worth noting that the experts do not recommend to pull it along the midline.It will only be a waste of materials and effort.
knitting or cooking fixtures?
Experts have long refused to weld fittings for various concrete structures, since its strength is not as high as during mating by the steel wire.It has long been invented a special machine, which can be used to make all the necessary manipulations.This gun is big enough, but with the help of one unit is sealed in just 2 seconds.Hand with this device easily dotyanet wherever a person is difficult to squeeze.
If we talk about how to knit reinforcement for the foundation of a monolithic type, then it is placed horizontally and vertically, bandaging the crossing wires, the ends of the latter tightened and sealed.You can use this special hook.Wire folds in half to get a loop that fits over the hook.Ends of the wire must be wrapped around the junction valve.The preform is placed into the device, and then rolled.Simple hook must be rotated by hand and the screw operates automatically.It is important to prevent corrosion of reinforcement, due to which the binding is impossible.
Talking about how to knit reinforcement of the foundation, it should be noted that there is another method that involves the use of the screwdriver.In place of the tip of the hook is inserted into the device, which rotates, thereby accelerating the process of mating.You can also use ready-made staples that do not involve the use of any tools.
