Wallpaper - chassis material for ornamental decoration.The process of pasting wall wallpaper is not so complicated, but is valued dearly.If you wish, you can save yourself the job done previously learning how to wallpaper paste, made from a particular material.Experience sticking come quickly enough.Moreover, modern wallpaper and vinyl nonwoven unlike traditional paper have advantages in quality and working with them.So, no need to cut the edge, the adhesive is applied only on the papered surface, such material can work alone, but better (faster and easier) to do it together.
As nonwoven wallpaper paste
These wallpaper basis is interlining - paper-like nonwoven material that is stronger than the paper is not torn or stretched, do not soak, do not shrink when dry.To wallpaper instruction manual, which is sure to read and observe all the conditions.
Fleece wallpaper comes in three forms:
- structural (Non-woven vinyl coated foam as a relief pattern which is easily damaged even nogem, so after nakoeyki these wallpapers necessarily paint to protect the top layer);
- finished structural non-woven wallpaper - they do not need to be painted;
- very strong, do not stretch, swells and chafing, they are recommended to glue the new homes.
As of nonwoven wallpaper paste?Prerequisites: smooth surface and check the strength of the plaster.The fragility of the plaster to be removed, and the wall - leveling.Next - clean the walls from dirt and dust.If there is no certainty that the new wallpaper does not appear yellow spots, it is necessary to check the acid-base indicator (pH) of the material of the walls.To do this, attach a piece of litmus paper dipped to the wall.If the litmus changed color, it must be primed to paste over the surface of a special deep penetrating agent, for example, Glotogrund LF.If the walls are whitewashed or exposed adhesive color, it is best to wash a layer of chalk or paint clean the walls.Prepare a special adhesive, follow the instructions that came with the product.Cut the roll of wallpaper on a panel of desired length wallpapering knife, making a 3-4 cm allowances.This drawing customize to match.Cut roll into a strip rolls.Before you apply wallpaper, you need to eliminate drafts in the room, so they dried up evenly.Be sure to unplug the wiring to prevent short circuits.Remove the sockets and switches.You can remove the baseboards.After pasting these items are set in place.
It is important to paste the front page of a strictly vertical, which is defined by a plumb line.Tie a strong thick thread load and lower it from floor to ceiling.Mark a vertical line on the wall stretched yarn pencil.This line - the boundary edge of the first strip of wallpaper, glue the remaining strip butt: edge panels fit snugly together.Apply a bead (or broad brush) glue on the section of the wall, to the width of the cloth.Roll out the roll from top to bottom, smoothing the wall with a dry soft cloth.Next you need to apply the adhesive to the other bands, trying not to get new wallpapers, roll from the ceiling to the floor next panel.The joints of panels needed more time to press against the wall with a special rubber roller.For pasting of corners you need to painting the wall going down to another centimeter by 2. Then you must carefully press the wallpaper to the corner and smooth.Wait a little until the adhesive to "grab", but not dry.Cut off excess wallpaper on the corner, you can use it pressed against a steel ruler and wallpaper knife.
How to stick vinyl wall
These are washable cover on top of a thin film of polyvinyl chloride (to simplify the material is called vinyl), and the foundation - from paper or nonwoven for reliable adhesion to the base.Vinyl wallpaper is very durable, able to withstand dirt, durable and beautiful, which is achieved in various ways Design: stamping, silk-screen printing, vinyl foaming.How to apply wallpaper vinyl?Yes, as well as non-woven.Besides flexible vinyl wallpaper, if necessary align the edges of the two panels edge can be slightly (only slightly!) Stretch.
