More recently, when the device is mainly used in the wells Rings concrete or wooden houses.These designs were quite a number of significant drawbacks.For example, the joints between the concrete elements are constantly was packed soil and silt.Therefore, they had to be cleaned periodically.Wooden houses as quickly rot and require replacement.
today for this purpose appropriate to apply a much more modern material - plastic ring well.These elements constitute a solid corrugated pipe.After the well is filled with water, the design of the rings does not allow it to contact with soil, as the absolute tightness.Such structures do not need to endlessly cleaned as concrete, for example.In addition, they are much more durable than wood.
height standard section of the order of 2 m. The weight of this cell reaches only 50 kg.Therefore, unlike the concrete rings, assembling of the whole structure can be produced without using any technique.Install pipe easy by the maximum of two people.The same applies to transportation.If the transportation of concrete to order special equipment is required, the ring
drinking well from the plastic ring is arranged in basically the same way as normal.Previously conducted geological surveys.To do this, refer to specialists.Independently determine the place of occurrence of the water is difficult.There are, of course, a fairly accurate ways, but a professional handle it much better and faster.Ultimately, the correct definition of the place of occurrence of the water closest to the site will also reduce the cost of work on digging.
To arrange well, actually pre-dug pit.These structures can be divided into two groups - public and private.The first type is arranged mainly on clay soils.At the bottom of the pit poured gravel, and then going to do well for the plastic ring.The seams between them are coated with sealant.The diameter of the hole should exceed the diameter of the rings by a few centimeters.In this case, the installation is much easier to produce.After mounting the ring, tear between the walls of the pit, and rings filled with gravel and compacted.
in loose ground arrange wells closed.As a deep hole in the ground to dig a problematic first dig a little.It set the ring.Then from under it removed the ground.Once it drops to a sufficient distance from the surface, it set the following items.So collect all the plastic rings for wells.Their price, by the way is not too large, and may be around 1000-1500 rubles apiece, depending on the altitude.As a result, unable to dig a hole deep enough and avoid the shedding of the soil.At the bottom poured gravel and mounted on top of the cover.
used these designs for devices not only drinking water wells, but also viewing, drainage and sewerage.In any of these cases, it turns out easy to use durable construction.Rings for plastic may well be very different diameter.Conventional elements of the figure is 60-90 cm.
