not at all complete hybrid cars include parking camera.And these cars it will be quite unnecessary, particularly when parking.
natural desire of the owners of these cars is the desire to correct the deficiency.Connect a rear view camera - a process which can handle almost any car owner.
What may be required if you decide to install it by yourself?You will need the following items: parking camera, you acquire in advance;small terminals or ready-made cables with terminals;Special clips for wires;Screwdriver (blade);pliers;washer hose;Tee hose washer;Multimeter (tester);drill.
In most cases the installation of parking cameras produce in a regular hole "native" head unit.Therefore, before buying a camera, make sure it is available.So, on your car parking is provided for connection of cameras, you went to the store where you purchased the best option for you camera.
Where do you start?A start is to ensure that not too lazy to check all used wire tester.Voltmeter you do not burn, but the light bulb - easily.
Before polmashiny disassemble, inspect the camera itself.Verifying each camera can be a bit different.Therefore, it is best to use the existing widely available through the steps of checking a particular brand of camera.Rear camera is made only after making sure that the camera itself is OK.The following is a rough plan of action.
Rear Camera: Connect
- is necessary to remove the rear door trim and rear frame with headlights.Unscrew the screws to remove the door handle cable.
- Make fitting camera, and then drill a hole under it.
- If desired, you can immediately install and washer nozzles on the camera.If you decide to install and then drill a hole and also for them, as well - a hole in the door to stretch the hoses and wires.
- Then refit the frame, but do not rush to tie it, first make sure that the camera is mounted in the direction you want.
- And then just make the very rear camera.Power for the camera is taken from the rear light.Put on a tee instead of the washer hose back door.Several times, check for leaks and eliminate them.
- Sam hose and wire may well fit under the door trim.Next you need to remove a lot: the seat belt anchors, lining, elastic bands.Get the wire, having held it up to the "head".It is necessary to connect and assemble all.
So you are connecting a rear view camera.To obtain images from the camera, you can use the parking replacement mirrors, or set inside the display or output obtained from the camera image on the navigation screen.But the rear camera to the navigator is done a little differently.
