How tinted car?This is an issue that deserves special attention.The appearance of the vehicle with good clearance and stunning tuning - that's what attracts the eye of others.Toning refers to elements of tuning.It is worth more to consider how to tint the car because the car will get through toning charm, brilliance and presentable.
Tint film, among other things, prevents many unpleasant effects on the car.Among them, burning skin, the instrument panel, acoustics and audio.In addition, toning creates a barrier that will prevent the sun dazzle the driver.
If tinting car windows film is not dismantled.Maybe just removed the door panels - and it is very rare.In addition, it is a very fast process: the car can be tinted full three hours.It does not scratch glass.Another plus, which has tinting film for car - it can be removed at any time, and the glass will remain intact.She also resistance: not afraid of no heat or cold.It does not shines not demetallised not peel or bubble.Plus it does not transmit ultraviolet rays.
How tinted car with his hands?Not as difficult as it may seem.This will require a spatula eraser, shampoo, knife blade, ruler and tape.
How to tint a car?For a start it must be thoroughly cleaned, washing off all the fat from the windows.If you do not do it efficiently, then later a film clogged hairs, dust particles, which can lead to poor results.Then you need to measure the glass (allowance is taken into account in the five centimeters on each side), and you can proceed to the film, or rather to its cutting.We need to find the direction of the transparent film.Then you need to take plenty of film and sprinkle it with water in which there is a sufficient amount of shampoo.The film should be damp and even wet.Then it is divided to the end (it is necessary to ensure that her party not stuck together), and the transparent part is ejected.Side adhesive tape is applied to automotive glass.Then require a rubber eraser, the center of which will need to round up to the edges of the water.The film must be followed to keep it from slipping.Attention!It is necessary to remove all the water.Then, an hour later, you can trim the film.But in any case, is not exactly on the edge - it needs to wait for about 8 hours.It is possible to improve the result of dry film hairdryer.
How toned car, or rather, its rear window?The film is attached to it by other means.It is necessary to carefully examine it first, then wash thoroughly.Mounting starts from the top.The wash liquid should be distributed on top of the already leached glass.Then, on the third part of the film is removed and the liquid is sprayed liberally on its surface.The same operation must be repeated with the remaining 2/3 of the film.As has already been said, we will need to wait a few hours and then can be corrected.And the council at last: the first 2-3 days do not need to open the windows in order to avoid possible deformation (this is the case, if the film is not of the highest quality).
