How to cover the roof with roofing material and do the job correctly and efficiently?So the question is raised by many ordinary people who decided to do without the help of professionals to lay the roof of his house, a shed or garage.Today are not so material as in Soviet times, and the new, with a stone crumb, styling consists of two layers of cushioning and reinforced with stone chips.Laying of the first produced on a perfectly flat surface with mastic, a gas burner and a skating rink.It is necessary to carefully examine the question of how to cover the roof with roofing material, and produce the right training base, as this depends on the quality and durability of the coating.Perform all work better in a warm, dry time - spring or summer.
Alignment
Before applying the paste to the surface, it must be carefully aligned, dry, eliminate the pits, mounds and completely clear from the resin.Indeed, in the days of old roof covered with a thick layer of resin, which is stuck on the roofing material.Over time, the resin begins to crack and leak.Also, the reason occurrence covered surface is the accumulation of tar condensate in the microcracks.The same will happen if the resin material is attached to the stone chips.Let us consider how to cover the roof with roofing material, that does not happen leakage.
must carefully remove the old paint, to bring down the resin until the tie.Upon detection of irregularities, it was appropriate to align the new screed, littered the horizon for at least a centimeter and more, so that water can easily run off the surface.This can be verified by laser or water level.With thread placed beacons, equaling to that, and poured cement screed.
process of laying
The base should be dry, with a broom to sweep resin, dust, dirt, and then apply the paste with a roller or brush.Next, wait for it to seize, adhering to specified on the package-time, which can vary due to temperature and humidity.After drying putty comes the turn of roofing material covering.It should be two layers: prostilochny without stones, and the top, with stone chips.There are also options for combinations composed from two layers.
How to cover the roof with roofing material?
initiate coverage you need from the lowest point to the upper layers had the opportunity to lap the bottom cover.To make it easier to work sheets can be pre-cut into the required pieces.Putting a first sheet is heated by a gas burner with a mastic material to a certain temperature, which temperature can be determined by the tape.Then applied to the sheet of mastic and special roller compacted.Undulating areas of roof specialists with experience trample down feet for better traction surfaces.
laying in the rain
Many people wonder how to cover the roof with roofing material in rainy weather.The answer is - to carry out such manipulations in the rain is strictly prohibited.It is better to wait for its termination, and drenched the surface dry gas burner.But it is only in rare and desperate situations.
cost
should also consider how much it costs to cover the roof with roofing material.On average, one roll of roofing material costs about 300 rubles.Depending on the area of the substrate is necessary to calculate the required number of rolls, to add on to this figure nails or a stapler.And, of course, have to spend on mastic.In comparison with other materials for the roof roofing is the most cheap and easy-to-use material.Such coating is practical and durable, it does not require additional maintenance.
