Construction bath is a very laborious process that requires thorough preparation.It is very important to be guided by technological require different room would not be warm and safe.If thoroughly come to the question of how to build a sauna from a bar with your hands, you can create a park complex with flower beds and a pond at the site.
What should be taken into account during the construction?The first thing to think about creating a support-pier foundation.For this commonly used concrete blocks.In order to construct a bath of the timber, it is necessary to stack blocks on the support.The distance from the ground at the same time should have about twenty centimeters.If you plan to make a large leisure complex, it should be laid on the four blocks on each side to support.The distance from the ground when it should reach about thirty centimeters.Naturally, you need to pay attention to the soil and the landscape of the place where the building is located.It is understood that under the block should be a special pillow of sand and gravel, the thickness of which is approximately equal to twenty centimeters.
So all earthworks finished, laying the foundation made.Now we should talk in more detail about how to build a sauna from a bar with your hands.The first step is to lay the base for about two layers of roofing material.Then you can begin to lay the first wreath.Also at this stage it needs to immediately put all sexual logs and identify places where later will stand partitions.In order to give a bath fortress must be dug under the walls all future logs of timber.Under the floor when it is necessary to put a board whose width is equal to forty millimeters.When will be the double rail also need to put the bar.Thus, all the logs are stacked on top of him, not vpilivatsya.
The next step is finding an answer to the question of how to build a sauna from a bar with your hands, you should proceed with the erection of the framework.It is worth knowing that the thickness of the walls of this should be up to about 90 millimeters.The optimum height of the bath is equal to 2.35 m. In total, this building should be about seventeen crowns.The length of the nails to be used for mounting, must be up to 200 millimeters.Remember utaplivat cap should be in a bar about three centimeters.This is required to do in order to crown the next when installing a nail did not create any obstacles.At a time when the log reaches a height of about 90 centimeters from the floor, it will be necessary to begin to cut through the window openings.Usually, their height reaches 1.2 meters, and width - one meter.You also need to leave about six centimeters above the cut through the opening to then was not straight.
How to build a sauna from a bar with your hands, when this phase will be completed?Once the frame is made, it is necessary to proceed to the installation of the rafters.It usually uses a simple board with a thickness of up to forty millimeters.Do not forget about the installation of insulation materials required.Then the rafters must arrive crate and put it on the roof.
After all roofing work to be completed, should begin to interior decoration.At this stage, you need to put first subfloor, which will subsequently travel along asphalt and insulation.After that you should make a stacking of the finished floor decking.The ceiling should be nailed directly to the rafters.This should be done through the asphalt.
question of how to build a sauna yourself, be considered.It remained only for small - to fix minor bugs and make the shelves, benches, stove and other required elements inherent to each such building.
