About ten years ago, the primary means of decoration of the ceiling was the usual whitewash, which applied a special brush or spray.Modern technologies allow to create a new design ceiling, but that you want to remove the old whitewash possible quality.Pasting polystyrene ceiling tiles, luting surface, staining the water-dispersion paints - all these kinds of finishes require the preparation of the base and remove the lime maximum quality.
method of removing the old lime coating know a lot.The most common of these is flushing water whitewash.The procedure would require time-consuming and physical effort, but the result is worth it if you plan to make a spectacular and high-quality repairs.First of all, it takes time to apply water to the ceiling with the spray, and further remove soaked whitewash metal spatula.For maximum effect, the work should be sectional and prevent drying of the wetted surface area.
tool to remove old coatings
If you do not know how to wash whitewash from the ceiling, remember that before you get started, you need to prepare all the necessary tools.This will facilitate the work and allow once again not to seek a spatula or a sponge in stained lime apartment.
You will need the following tools:
- average width of spatula to remove the composition;
- the spray of water to wet the ceiling and soften the layer of whitewash;
- respirator to prevent small particles suspended in the respiratory system;
- to protect the head, hands and other parts of the body should be put on a scarf, gloves and work clothes;
- film or paper will help to protect the furniture and floor from getting the dust that after work do not wrestle with the question: "How does all this wash?"(To solve the problem of how to wash whitewash from the ceiling, it is much easier than to wash it off the floor and furniture);
- and do not forget about the ladder, as without it you are unlikely to pull out a to-ceiling windows, and the use in this case, a table and chairs is undesirable from the standpoint of safety.
This method is most accessible for those who do not have the appropriate skills in the question of how to wash whitewash from the ceiling.The main disadvantage of the technology is the formation of a large amount of dirt in the room, which can be difficult to remove.
Other methods of removing the whitewash
If the above method does not suit you, you can try other methods:
- removal method using glue is a process of wetting the ceiling a liquid solution intended for wallpapering and further schischenie spatula.By this method, whitewash lime is not converted to fine particles, and the slurry thus does not contaminate the area.
- stripping soap.To produce the solution need 3 minced soap, 10 liters of water and a few tablespoons of salt.The resulting composition required for wetting sponge large and rinsing underlayer without using a metal spatula.
- If you do not know how to wash whitewash from the ceiling, and any of the methods associated with the formation of a large amount of dust in the room is not acceptable to you, use a primer deep penetration.Simply apply makeup on the ceiling and keep the finish on top of the old lime coating.
prepared substrate may be subjected to any further decoration: stained roller, paperhanging and tiles, installation of suspended ceilings.Rinse or wash whitewash - you decide, but if you treat such a serious matter lightly, you can cause serious problems.For example, a whitewash could collapse with a thick layer and damage the new decoration of the ceiling.Stucco in the apartment - a complex process, if you doubt their abilities, invite experts.
