For those who like myself to repair the house, replacement windows will not seem too difficult.But in any job has its own nuances, so in this article we will talk about how to install plastic window.
If you decide to replace the old new window, you first have to remove something that is already worth it.This will require the following tools: a chisel, a hammer, a small crowbar, chisel and the bag in which it will be possible to collect all the debris.
course, require another set of tools, or how to install plastic window itself?To do this: hammer, hammer drill (Drill), the level (not shorter than 60 cm), screwdriver, wooden wedges and a set of hex key.
How to install plastic window
- When you get brand new box, you need to prepare it for subsequent installation: remove the flap and remove the old frame.
- can advance a pencil to mark the places where the alleged fixing holes.If the opening for the window has no specific features, it is permissible to immediately drill them.This is done in advance so that when the frame alignment in the horizontal and vertical plane did not have to pull it again and drill holes in it.However, if you need to check to see whether they match with any special place in the opening, the course mark and pre-drill does not need anything.Further details on how to install plastic window.
- Install a brand new plastic frame in place of the old.
- expose it in the opening so that both sides had the same gap to the wall.You can do this by eye, it is possible for the line (how convenient).It is better to use wooden wedges that you can fix the structure in place.Without
- level in this case is impossible.How to install plastic window properly if you do not keep track of his position?Exactly fail.Therefore, using the level exhibited frame in the horizontal plane, so that there is no right or left misalignments.This procedure is also necessary to use wooden wedges or any plate, specially prepared for this.
- Do not forget to check that all construction is not skewed forward or backward.
- Next are drilling holes for anchor bolts in the walls of the opening through the ones we previously drilled.
- Insert the bolts, check the level of all final.Then tighten them, making sure that the frame is not twisted in any direction.You should be careful when tightening, if you overdo, you can do to break the frame.
- Set glazed and hung on his sash.Next you need to
- zapenit joint between the frame and opening the same layer on all sides.Working with assembly foam depend on the brand and manufacturer of those characteristics which are indicated on the container.Carefully read the instructions.
- Set on the level of the window sill and we coat all joints with silicone to prevent blowing.
- At the end of the ebb fasten to the window sill profile with screws from the side of the street.
Now you know how to install plastic window.Let this update will bring you the joy of home and warmth.
