Lights - an integral part of any vehicle.Gradually they begin to fade, and the reason there are scratches and chips that appear over time.To restore its former beauty and functionality range, they need to be polished.
How polish lights?Of course, the garages will be happy to offer its services to motorists, however, this problem can be dealt with independently.This is what we will discuss in this article.
Instructions - how to polish the headlamps:
1. So, first of all you will need masking tape, which is necessary to seal all around the headlights, require polishing.This is done to protect the car from the mechanical effects, which you will incur their lights during polishing.Polish them will not be difficult if you approach the matter responsibly.
2. Next, take the sandpaper with polishing machine and start working.It is necessary to treat the surface of the range so that there was an even layer of opaque color.When processing surface of the headlamp is important to ensure that the paper was always wet.And to see how the process takes place, to dry and clean the headlights.
3. For drying and wiping lights probably best to use a cloth-drying, which can be found in the automobile.Of course, even matte layer assumes a flat surface, which is not old scratches and chips.When you achieve such results, it will be possible to start polishing itself.
4. How polish lights without special sponge?Nothing.Therefore, polishing must be purchased as a special sponge.Before you start to use it, it should be thoroughly rinsed with water, on the surface there was not the slightest grain of sand - otherwise this is a sponge made a lot of scratches on your new car headlight.After washing, the need to overcome it and to fix in the polisher.
5. polish each specialist deals in its own way: a sponge, and the headlamp or a sponge and a few drops of the headlamp to different places.Here the work of their preferences - the essence does not change.
6. Polishing should be carried out uniformly, without stopping at any one place.Otherwise, it will begin to occur overheating and scorching.Also, in order to avoid such difficulties, it is necessary to monitor the humidity sponge - dry will also overheat and burn.
7. After completing the above steps, you will get a shiny, smooth surface of the headlamp.If you do not find any defects, you can start using fine abrasive polishing.Before the start of the final polishing sponge should be well washed and dried.If you find after polishing on the surface of headlights left some scratches or dull patches, then polishing took place is not entirely correct.In this case, you must repeat the entire procedure from the beginning.Even if you know how to polish the lights, but do not abide by these rules and do not try, then nothing good will come.
also important to remember that the wax after drying leaves white spots, which are very difficult to eliminate.Therefore it is necessary to thoroughly wash all places, which could get polish during the procedure.As a result, the headlights on your car will shine and shine like new.
Now you know how to polish the headlamps so that they become like new again.Good luck!
