What could be more beautiful fresh cool water on a hot summer day?Placing the pool on the site, it is worth noting an important factor will be the location.When you select must be guided not only by the sun's rays, the size and the ability to install additional furniture around, and design features.Since the pool may be configured as a frame and the pit is recorded, and soil.
course skeleton base pool is much more convenient, since it is possible to move around the perimeter of the construction site, it is easier to install and maintain.It should also be noted that there are two types of frame pools - fully and partially located on the surface.
now look at how to make the pool frame type.For the construction of need - boards, beams of pine, sealant, diesel, crane, galvanizing or aluminum sheets.The lower and upper harness made of planks and beams, and intermediate layers - from thick planks.What is good in this kind of - is that it can be dismantled for the winter season.In this case, and the construction continues, and in the summer you can enjoy swimming again.To provide additional stiffness also used planks of which are made braces.Also, do not forget about sealing to prevent water from leaking.For this process of building the tree is treated with special materials.
Many wonder about how to make the pool so that water can be easily changed.It's quite simple, that is why we have acquired and the crane.It must be installed on the bottom and then by means of a flexible hose attached to it, can be easily drained.In order to pool looked nice, you can use a variety of decorating materials.
How to make a pool type of excavation?On the one hand, it is very time-consuming process, and on the other - it is less expensive, and such a structure will last for many years.The most difficult - is to dig a pit.Should be weighed against the size of the plot and the pool itself, because a very large structure on small land will look unprofitable.When choosing a site is worth considering how to make a pool in the country so that it is easy to fill it with water, because the costs of the liquid will be large.
When excavation is necessary to remember that the depth should be at least 1.5 meters.Also, to further it easier to lay the waterproofing, you need to carefully remove all the root system.The next step will be necessary to make another small hole in the center of the main pit.Its depth should be 50 cm and a diameter of 40. Then the ground is covered with a hole in her, but he had a little lower than the level of the soil.For the next step you will need sand, which covers the entire surface.The thickness of this layer is 20 cm. You can now waterproof.
She will serve as a common construction film, which can be purchased at any store with building materials.Waterproofing should put so that its edges are performed at 50 cm from the pool, thereby not letting water into the soil.Also, equipping the drain, you must be sealed properly place the contact tubes and films.You can use the pump and to pump water.Now you have to decide how to make a swimming pool inside, you can, for example, to put his tiles.
