today when listening to any music tunes everyone wants to take the full range of sound vibrations that would be far from complete without the most important device in charge of the bass.It is, of course, on the subwoofer, which allows you to take any melody to great effect, both at home and in the car.That is why today, without a subwoofer is not for sale, no musical setting.It may seem that its structure is very complicated, but it is not.A closer look reveals that the subwoofer to make their own hands would be the power of man, which has elementary knowledge in the field of electronics.
So, in order to construct their own low-frequency device, we need the following materials:
- directly to the subwoofer, and power of the brand depends on what device you want to get a result;
- low-frequency amplifier for the subwoofer;
- processing unit sound for music channel;
- plugs, connectors and terminals;
- speaker cable broad cross-section;
- set for soldering.
As seen from the above materials, all this is in the free market, so to get the necessary devices and elements of particular complexity is not.Thus, the subwoofer can be made with their own hands in the home, which is what many craftsmen.Now you need to prepare all that is needed for the manufacture of wooden frame of our subwoofer.It should prepare a sheet of plywood 20 mm thick, screws, sealants, foams, and screwdriver.After that, even if you plan to make the most simple subwoofer, you should use a computer program JBL SpeakerShop, which will help you calculate the amount of housing.The latter must comply with the power of your system.This is a very important parameter and neglect them in any case not worth it.You must specify all the necessary data on the audio device that you purchased, and the program for a few seconds will give you the optimal amount to achieve high-quality bass sound.
should be noted that the subwoofer with their hands on a mandatory basis should be made because of the tree, because this stuff is the best, not only for low-frequency devices, but for ordinary music speakers.Then we mark up the plywood, sawn and assemble using screws and sealant all together.The back cover is fixed at the last turn, because it is pre-set speaker connected to the amplifier and sound processing unit.Cable outlet to the outside, and finally fasten the back cover of the resulting dynamics.Now you only test our subwoofer, connect it to a stereo system.
So we figured out how to make the house a subwoofer, using the materials at hand to the body.It should also be mentioned that in the calculation of the planned capacity must take into account the parameters of the room in which the device will be.The main thing is the amount of space, the presence of a window and wall finishing material.Be sure to check out our recommendations for acoustic effects which may occur in places with too high or low ceilings, as well as in-room studios.
The same pattern can be obtained for the speaker and car subwoofer having made their own hands.It is best placed in the luggage compartment of your car, because in this case it will take a minimum of space, and its effect will be quite serious.
