debunk a few myths about the diamond drilling and cutting of concrete (reinforced concrete) with a diamond tool.
Diamond cutting silent
Of course, the performance of noise in comparison with the impact method of diamond cutting and drilling produce less noise, but to talk about the complete absence of it is not necessary.Cutting wall with diamond tools - is in any case a mechanical action, accompanied by the noise of the engine running (especially felt he would be at work Benzorezy), the noise of rotation of the cutting element (be it diamond blade wall saw or drill bit Installation of diamond drilling), the noise of contact of the diamond edgewith the surface (especially when passing through a layer of reinforcement).Therefore, the noise disturb neighbors during repair or remodeling still have.
wet drilling and cutting of concrete homes is fraught with flooding
When redevelopment and renovation in private homes often tenants in choosing between technologies of diamond drilling tend to dry drilling, for fear of flooding as a private apartment and the neighbors below.However, when conducting such work often need to drill or cutting structures with thickness up to 300 - 400 mm, can easily cope with anything and manual cutters, do not require consumption of large volumes of water.If the work requires the use of powerful drilling rigs or wall saws, the operation of professional tools makes it possible to apply the cleaner drainage, which prevents the ingress of water on the floor.
Myths about Diamond disks
The larger the diamond - the better the diamond blade
In fact, the number of diamonds, as well as their size is directly dependent on the destination disk.For instance, diamond wheels designed for cutting granite, have minimal number of diamonds, but they are larger and slower erased.In diamond tools (cutting wheel) for concrete soldered larger number of small synthetic diamonds.
higher stiffness bunch of segments, the better
Rigidity bundles determined by the purpose of the diamond disc.From optimally designed taking into account the stiffness ligament abrasion of the processed material will depend on the endurance of the cutting blade.Too rigid ligament lead to clogging (ligament wear slower, diamonds are exposed enough, performance falls).Too soft bundle will wear out faster than diamonds, which will lead to the fact that they have not fulfilled their service life, will fall.
Thus, diamond tool , of course, advanced and high-performance technology, which is used for drilling and cutting concrete, but at the same time is not cheap.Therefore, to fully utilize its resources must be carefully refers to the selection of the tool and its operation.
