Before you begin to address the question of how to disassemble the iPhone 3GS, you need to understand that to carry out this operation you are at your own risk.If you inadvertently be damaged any of the details, in this case, the technical service may refuse to help you, and this happens in most cases.Therefore, we recommend pre-think whether you are alone or repair is still worth trusting professionals.
Equipment required
to dismantle iPhone 3GS, you need to have on hand a set of special tools.The paper will be used screwdriver watch collection, borehole or plastic blade with a pointed, however, you can use a mediator.You also need to use a thin metal blade, but still recommended to the presence of a scalpel.For better supply lighting should be used carry or table lamp.If you need to replace the glass cover on the device, in this case must be at hand dryer.
Procedure
So, let's get down to the question of how to disassemble the iPhone 3GS.We will act in a certain sequence.If you use our instructions in this case, be sure to remember that all items must be observed in a strict sequence, otherwise you can only harm your device.
Display
The first thing you should view the iPhone.If you have studied it carefully, then on the bottom you will notice two bolt, which first need to unscrew.When this is done, you can open the display unit, it is done as carefully as possible, because otherwise, you may damage the cables.To remove this element, you can use a thin plastic or metal object, but we recommend you use a suction cup so you do not damage the edges of windows.If you decide to learn how to disassemble the iPhone 3GS, then in any case it is impossible to hurry and be sure to follow the instructions.As part of the screen to be moved and raised, you should start off with a plume motherboard.It is a necessary element in the upper right side of the device.After you've turned off the trail should take disconnecting the second, which is for the sensor.The third leads to the speaker.You should also disable it in order to completely disconnect the opportunity of the screen.If all is correct, then we are interested in the module easily separates from the bottom of the device.Now you know how to disassemble the iPhone 3GS for replacement of the screen or protective glass, but if you need to continue the process, for example, to install a new motherboard or battery, then follow the steps that we give below.
Deep Repair
Pick up the bottom.On the face side you can find the screws on each side of three pieces.Turn off the elements and separate the display from the window frame.In fact you need to be attentive in the separation of the display.If you want to replace the glass, in which case it will need to be heated with a hair dryer, but if you do not plan to do this, use a heater in general we do not need.How to disassemble the iPhone 3GS, now you know, and if you act strictly according to the above instructions, then you can do without the services of specialists and no damage, but rather to correct the problem yourself.That's all we wanted to share as part of the material.Thank you for your attention to each user.We hope you will help guide.
