lack of hot water in the house may be subject to a number of reasons: to provide domestic hot water shortages, seasonal shutdown, etc.From this situation there is a logical way - the connection of the heater.This can be done by yourself.And then the question arises: "How to connect the water heater?"To begin to become familiar with its design features, the type of execution, as well as the wiring diagram.
It is said that electric heaters are of two types: storage and instantaneous.The design of the flow enters the heat exchanger through which the cold water and immediately heated.Accumulation features thermo-insulated storage tank, the amount of which varies in the range of 5-1000 liters, which is carried out by means of a permanent water heating PETN.For household appliances power consumption is typically 1-2 kW.So, if we talk about how to connect the water heater, you should consider a lot of nuances.In terms of performance instantaneous water heaters are relatively simple devices.They allow you to heat the water instantly, that is when you open the hot water tap, it appears instantly.Often these devices are equipped with automatics, designed to set the desired water temperature.It is widely believed that the use of the heater leads to substantial costs on electricity costs.It is a fallacy, since even at high power consumption it is much less time than the storage heater.It heats only part of the water used.This leads to the fact that the same amount of electricity is consumed.The main drawback is the large power consumption.That is why the answer to the question "how to connect the water heater" is worth noting that the wiring to the special requirements.
to connect the flow heater is required to reach the house or apartment a separate line with individual electric protection, or after the installation of the heater you can stay without electricity.Correct to use copper wire 4 square millimeters or more.For a device with capacity of 8 kilowatt-section must be selected at least 6 square.mm.
If we talk about how to connect the storage water heater, it should be noted his lower demands on electrical wiring, due to the lower power consumption - only 1-2 kilowatts.However, in houses with old wiring is correct to err, having a separate group connected through her machine.Copper wire with cross section of 2.5 square millimeters is quite suitable for this purpose.
If you understand how to connect a water heater, it is worth to say about the merits of the storage type.In its first advantage is that it allows to heat the water bath, and to be fed to multiple taps, that sometimes it is necessary.In the case of power cuts in the house there will be a supply of hot water.
Now you know how to connect the water heater.
