sliding doors have a system console.With this structure, the movement is along the two roller supports which are mounted on one side of the passage.These gates can be used in any area of our country, as their work is not affected by snow drifts.The web of the front edge located on the trap, where they are in the open state.Thus, the unloaded roller bearings, and so continue their long service life.
Cantilever sliding gates are designed, is a rail, set traps and roller bearings and shaped tubes.Manufacture of sliding gates is based on the use of quality components, manufactured in our country.Depending on the size, you need to use very durable roller bearings and rails to withstand heavy loads.The size of the gate is wide and 7 meters.Making an individual order, they can be made with a width of 12 meters.The height can be up to 3 meters.The design is always processed primer and painted in any color.
Made gates with built-in automation, it all depends on the customer.Automatic entrance gates require additional training of their paintings.To do this, the entire length of the rail to install a metal rack to ensure operation of the drive.The sliding versions use control unit with radio receiver.Such gates are often installed in private homes.
powerful drive has a built-in power that occurred flexible variation of the composition of the system.The kit should include automatic gate remote controls, photocells, racks, signal lights, selectors, antenna and so on.
when production takes sliding gates, the cost will depend on the self-supporting rails and roller bearings.When making cheap copies usually try to save money.Therefore, begin to use products of unknown producers of low quality metal or replace their homemade counterparts.
design sliding doors can open them manually or with an automatic drive.When the sliding gate is being installed, it is done so that the components are not touching the ground.The upper part is fixed by means of lateral rollers.They can be used to limit the amplitude of the swing gate.Manufacture of sliding gates is strictly limited standards helps all the elements are in the correct position to maintain balance.
sliding doors may have four kinds:
1. Open the bottom of the profile with a beam located.
2. overhead beams.
3. With closed-profile beam with a bottom location.
4. Telescopic gates.
All of these types have their scope and operational features.
In the selection of items you need to consider is where the gate will be installed.It is better to entrust the manufacture of sliding gates and installation professionals not to worry for their smooth operation.
