pyrolysis furnace in its work using the principle of combustion in oxygen with the release of the so-called wood or gas generator.It consists of fifty percent of the nitrogen and as much of a mixture of carbon monoxide, hydrogen, carbon dioxide and methane.
Many companies specializing in the production of heating boilers and furnaces, producing such devices.Their operating principle is almost the same in any design.Now their body pressed layer talkhlorita.This eco-friendly mineral has a high specific heat capacity.It accumulates heat, which is then slowly gives increasing thermal inertia.
Novelties device
pyrolysis furnace consists of two parts.The interior compartment of the cylindrical furnace is built into the outer casing.The space between the ducts set heat output.Pyrolysis oven is equipped with an inflatable fan, which is controlled by a wall thermostat.This allows you to keep the temperature in the rooms in the desired range.
The pyrolysis furnace "Burelyan" convective pipe protect slim body by thermal shock.In more modern hull design is performed thicker resilient to these shocks.New devices of this type have a chimney made of stainless sheet steel with a special heat-resistant insulation "Korund", which greatly simplifies the complicated chimney.Last equipped with condensate trap and removable flange for cleaning.Under the flange has a faucet to drain condensate.Such an apparatus is loaded only twice a day.At the same time the wood do not burn and smolder.It develops efficiency up to 70%.
pyrolysis oven - the principle of the
At any pyrolysis furnace combustion of wood takes place in two of its offices.One gas is emitted, and in the other - it afterburning.They have gas burners.
their work next.The fuel chamber laid the wood.They should be dry.Pyrolysis furnace can run on fresh wood, only much worse.Kindle logs.The door of the combustion chamber is tightly closed.After that, turn on the fan-exhauster that creates a negative pressure inside the enclosure.Due to this, through the diaphragm into the combustion chamber gradually externally supplied oxygen.As a result of the gasification process is started.The resulting gas with a fan-smoke exhaust enters the lower compartment, lined with fireclay brick, and burn there, giving heat to the water pipes.The temperature of the wood combustion gas is sufficiently high and reaches 1,250 ° C.
power heat generator regulated on and off the fan-exhauster.Such a device operating on the principle of combustion of wood gas, a non-autonomous.For the fan need electricity.In case it can be set off diesel burner.Despite its complexity, these devices have a higher efficiency than conventional ovens.It remains a little combustion products.Its combustion chamber is usually greater than the normal.The combustion process it adequately controlled.
There is another trend - the furnace Kuznetsova.The concept of such a device is to receive fuel from the maximum heat and use it for space heating with the highest efficiency.They are moving heated gases is not mandatory, and naturally in accordance with the laws of physics.It uses a special device - caps, which allow you to do.
