Selecting car lifts

click fraud protection

situation is such that no client will appeal to car repair, if it is not well equipped.The most necessary and important presence is considered car lift , without which it is almost impossible to produce a quality repair of your car.With their help it is possible to diagnose the suspension, engine or transmission repair, change tires and perform preventive maintenance.Thus, the owner of car-care center should seriously think about choosing the right equipment, according to their needs and finances.

First and foremost, you must learn the basic characteristics and perform their operations.

Main features: speed, load, height, type of construction, clearance.

Capacity - this is the weight that can lift easily and safely lift.For a small car weight is usually 1.5 - 5 tons.

lifting speed - the difference between the models is negligible, some one - two minutes.Possess more speed electromechanical devices.

Lifting height - it usually does not exceed two meters.The overall height of the elevator car on average 3.5-3.7 meters.If you plan to serve the minibuses or "gazelles", the height should be at least 4 meters.For tire works, there are special lifts, which have low lifting height.

Clearance - lowering the minimum possible height of the clutches of the installation.As a rule, this height in the range 95-110 mm, but there are special elevators with a low value in the range of 75-90 mm.

Type of lift causes hoisting and setting rules for the car.

There is a division of the type of drive : electromechanical fluidly, electro-hydraulic and manual.

By design divided into rack, scissor, mobile tower, plunger and special.

for cars / trucks and motorcycles produced various lifting equipment.

Regarding safety: specific requirements for mobile lifts and ski lifts operating outdoors.Two post lift - garage equipment special attention.

Keep in mind that depending on the type of lift is different and the frequency of its service.For example, electro-mechanical lift requires daily inspection gaps a safety nut.If the gap is too small - do not delay the replacement of worn-out parts of the lift.Moving parts must be lubricated periodically.On the expensive models grease automatically.

We hope that these tips will help you in your choice.