majority of motorists, which is logical, protects the iron horse from all sorts of damage.A pleasant ride on broken cars scratches, another important in the future to sell, and profitable, and there is such a pity that his car, trying not to give him "injury."In most cases, if an accident does happen, it is primarily concerned with the bumper.As you know, almost all cars today are equipped with plastic bumpers, so the need arises, as a local car repair.
Of course, there are times when the bumper further damage is not getting through, then another question arises about how to repair a plastic bumper.In fact, not too many options.As a rule, they do it in a car repair, but the power of virtually every motorist.
This will require fine-grained mesh, a soldering iron, preferably 100-watt, little solvent and the like of the table on which to put a bumper.It bears would be building a hairdryer.To begin with, the bumper must be removed from the vehicle and clean it from dust and dirt, the place of failure should be carefully washed, followed by dry and free of grease, as a degreaser solvent may be used 646 or 647, which is actually found in any hardware store.Car 650 is used because it is used to dilute paint and is available constantly.
«How to repair the bumper with his own hands" - articles on the subject on the Internet a lot, but usually find step by step instructions quite difficult.But do not be distracted from the topic.We stayed on the fact that all you need to dry.After that, you should use the hair dryer, but if not, do not worry, it is needed to more precisely set the pieces together.It is known that objects expand when heated, so in this way one can avoid gaps in alignment.
This is an important step, since the service life will depend on how to repair.Bumper during operation is in a rather aggressive conditions, it accounts for hitting the pavement, if a country road, the grass, which can be quite tough, removes the paint even to the primer, until the plastic.Therefore, the state must constantly monitor the bumper because of damage in the form of tearing fixtures can be prevented by pre-strengthening them.
Of course, if all this is not done, and not to protect the front part on the slopes, on the rise, there is a problem and the question of how to repair the bumper.But we will continue our "instructions."Now it is necessary to briefly leave the bumper and cut into rectangles 1x2sm grid, it is desirable to be coated with stainless steel because rust can perform in the slot with the remainder water.
then heated soldering iron is applied the grid, and then pressed against the first so that the molten plastic is made by the cell.Smoothing the resulting ribbing necessarily, not even worth it, because this would harm the strength.It is necessary to specify that all operations are performed on the inside.Of course, it would be better to do the same with the outside, but then there is a need of painting.The article briefly describes how to repair the bumper.
