The mission of the greenhouse "Uralochka" is to create the most favorable climate for the cultivation of crops in home gardens and suburban areas.It is a metal structure of the shaped tube coated with corrosion-resistant polymer coating that is applied at the factory.
frame greenhouses "Uralochka»
frame having a higher strength is made of steel profile 20 by 20 mm.The height of 2 m, a width of about 2.5-3 m. Greenhouse "Uralochka" does not require the installation of the foundation and can be mounted directly on the ground.All steel structural elements are covered with polymeric corrosion paint, rust protecting the greenhouse, the temperature difference and the negative atmospheric influences.
Fixing to ground is made with the supplied bolts.The frame has two end doors and two windows.The kit includes everything needed to build the nuts, locks, screws, handles, wind hooks and screws for fastening polycarbonate.If necessary, separate greenhouse retrofitted side vents.
Greenhouse "Uralochka" enhanced differs from the standard model by the presence of a rigid frame by increasing the number of arcs going every 67 cm, but not as in conventional models by 1m.
Benefits
- greenhouse design "Uralochka" thanks to the arched structure is able to withstand increased snow and wind loads.
- durability of construction due to anti-corrosion coating.
- is possible elongation greenhouse "Uralochka" through-extending unit, which is very convenient.
- Fully equipped all the necessary elements to build a greenhouse.
- Polycarbonate, which covered greenhouse, is durable, reliable and light material of low weight and high thermal conductivity.
- To set the frame does not need foundation.
Options greenhouse
kit greenhouses includes all the necessary elements for a sufficiently reliable fastening cover.In addition, it included detailed instructions illustrated with all stages of assembly.
Greenhouse "Uralochka" has the minimum number of parts, which greatly speeds up the assembly and allows the construction of even their own hands.
greenhouse frame Packed compact enough.Its structure includes the following units:
- base and longitudinal ties - 1pc .;
- ends of the assembly - 1pc .;
- arc greenhouses - 1 pc .;
- fasteners and fittings, passport and assembly instructions and assembly - 1pc.
Assembly Building greenhouses polycarbonate "Uralochka" done very quickly: 2 people can do it for 3-4 hours, while having a minimum number of tools.
assembly stage
- First you need to select a site and smooth the surface.
- Before performing the carcass should close the ends of the honeycomb polycarbonate.This is done as follows: on the smoothed and hard surface are cut using a knife on a construction line 3 polycarbonate sheet with a length of 2 m, width 2.1 m. Then unpack the package with the ends of the greenhouse.One of them is placed horizontally so that the door and opened it on the pane facing directly upwards.On the surface of the end put a sheet polycarbonate face up (it is marked on the protective film).Previously the inside of the plate, remove the special protective film.
- Likewise performed closing the other end of the polycarbonate.
- now built and installed with the help of the level of greenhouse foundation pipe.
- Mounted trimmed ends of coated and connected to the base.
- mounted on the guide arc.Connect the ends of the arc and longitudinal ties.
- Running securing frame to the ground.For that are driven into the openings, which are located in the corners of the frame and in the joints of the base parts, pins.
Performing mounting polycarbonate frame greenhouses start with the frame edges.
- arc stacked on a sheet of polycarbonate.
- laid material is fixed with screws.Similarly
- held opposite the closing of the frame.The average of the last third of the leaf is covered and secured with screws.Further fixed to the base of polycarbonate sheets.
- final step - installing door handles.
