fans drive the wheel should pay attention to the fact that motorcycles are increasingly flickering in accident reports.Therefore it is necessary to take seriously the safety standards and the technical condition of machines, for example, to regularly measure tire pressure ATV.In addition, this setting determines the correct balancing technology, traction, handling and normal integrity of the tread.ATV - is off-road machinery, and the normal state of the wheels ensures its operation when traveling over rough terrain.Consequently, only optimally matched and properly bleed the tire allows to enjoy fast and safe ride.
strategy choice of tires for motor vehicles
What to consider when choosing tires for the ATV in the first place?Of course, the tread pattern which causes the grip and stability of the machine as a straight track and in curves.If you buy tires that were in use, it should take into account the extent they wear and rubber, and relief.Improperly selected products reduce maneuverability and transport capacity.You need to know that the ATV tires diagonal design, rather than radial as a conventional vehicle.These products are made from several cord layers, stacked perpendicular to each other.ATV Tire pressure should be low, thus ensuring the protection of off-road equipment.
contact area of ​​motorcycles and soil
tire pressure ATV provides such an important figure as "contact patch".Normal rate determines the optimal size.For example, if the pressure is low, the "contact patch" is large, and therefore, the protector will quickly become deformed, weakened grip, motorcycles begins to "walk" bad "holds" the terrain and the driver does not respond.If the ratio is high, that is, the camera is pumped, the ATV, and soil contact is reduced, decreasing the flexibility of the tire sidewall and substantially reduced amortization.Only optimally inflated tires provide high maneuverability, good high-speed mode, a stable resistance required depreciation and driving safety.
Features of movement on the various routes
Which path would you have chosen either for skiing motortechnique, before going to the track to check the tire pressure ATV.When choosing a trip, you need to understand that when you walk on the surface of different types need different indicators in cells.Soils can be solid concrete, asphalt or firm ground.The road can be softer and more mobile: roads, sand or snow.Which tire pressure is necessary to ensure the ATV in either case?When traveling on the road recommended parameters from 0.35 to 0.83 bar.If you have to ride on a hard track, the pressure better to increase the nominal value of 25-40%.Some drivers in the first case it is recommended to pump up the rear wheels a little more.
tire pressure CFmoto
One of the most popular quad - CFmoto.It is often used in a variety of test drives to determine the optimal parameters of various indicators.That is, at the start of the pressure in the tires ATV CFmoto set of standards, and then to change his route and make measurements.Indicators from 1.1 to 1.5 bar proved to be optimal for the movement on the pavement for better maneuverability, and on tire wear.Reduced rolling resistance on the road.But in areas off-road meetings with the irregularities were felt much tougher.In general, the pilots concluded that if a large part of the route runs through the dense coating chambers to better support high blood pressure.
