Every computer owner certainly one starts looking for the answer on how to set up a local network between the two computers.This method of communication multiple computer systems are still incredibly in demand, despite his advanced age (this year he turns 47 years old).This is not surprising, given the very low cost of deployment, and the availability of the hardware configuration is quite decent by modern standards, the transmission speed of digital information.Furthermore, the use as the carrier medium allows the wires to achieve a high data reliability.
Materials and equipment
As you know, the local network of computers can effectively solve the problem of communication between computer systems.You only have to buy a special cable (usually a twisted pair) defined at the ends of the connectors, connect them to the outputs of the two network cards of computers, and of course, make adjustments.It is desirable that the card supports the same standards.All current board already contain built-in network adapters.Note that when connecting multiple systems using a switch, hub or router configuration of network cards will be different than when installed local area network between the two computers.Nevertheless, the principle is the same, so we continue to look at a simpler version.
How to set up a local network between two computers
So, bought the cable and connectors are connected to the computer connector.Just note that the length of a segment must not exceed 100 meters (for 100 Megabit).In addition, the problem of forward and reverse crimp connectors for a long time remained in the past, so this question can not even raise (sometimes on this feature for some reason, remember).The next step you need to adjust the work of the network card.To do this through the control panel, or by selecting "Properties" tag "Computer" to proceed to the "Device Manager", which displays the system in the list check the "Network adapters".There should configure it to the adapter connected to the cable.In "Advanced" should be forced to set "Speed & Duplex" to the desired mode.It is noticed that the auto-negotiation may slow transmission.Well, since we are considering how to set up a local network between two computers, the same steps should be performed on a different computer system.
Adjust the address
next step is to open the "Network Control Center" (properties of the icon of the monitor next to the clock in the system tray) and select the list on the left click "Change adapter settings".It is necessary to cause the properties of the network card that was previously configured in the "Device Manager."Further, if the question is how to set up a local network between two computers, the protocol version 6 can be disabled by removing the tick appropriate entry - it is necessary for the Internet, and yet the vast number of small systems working successfully without using proventhe fourth time.It is necessary to make changes to the TCP / IP 4: double clicking and selecting "Use the following address".It is necessary to register 192.168.0.1, mask and expose the network to 255.255.255.0.No other changes are required.On the other computer's IP address will be different - 192.168.0.3.Other settings are identical.
If the network does not work
Sometimes you have to put the same working group.To do this, call the properties of the "Computer" and proceed to "Advanced Settings".In the window that appears, select the tab "Computer Name", then "Edit", and then register the workgroup name there.It is important that it was the same on both computers.
