mice - a manipulator, allowing the user to control the cursor on the screen.This device is quite sturdy and with careful use and proper care can last for many years.Very often, the mouse stops working because of the things a trifle, and there is already the owner chooses what to do: throw away the old and buy a new arm or try to find out the cause and repair the damage to his assistant.At this point the question arises, how to disassemble a mouse, to reach its internal mechanism.
There are several common types of damage most computer mice, repairable.This may be grinding the wire at the outlet from the housing, if the wired mouse, galling buttons usually left because it is used more often, or poor work wheel.These are the breakdown that can correct and extend the life of his assistant.
Though the type of the device keypad sounds simple, but it is often a problem with how to disassemble a mouse.Depending on the model, it is fastened with one or two screws.In some devices, the screw is in sight, but most of the manufacturers of fasteners are hidden under stickers or glides for a more aesthetic appearance.Therefore, to find the screw, you need to carefully examine the label for the presence of depressions in the form of a circle, if any, you need to peel it, if not, then you need to look at glides.The last should be removed carefully to then put back in place, otherwise the mouse will not be good to slip on the mat.
unscrewed all the screws, you must disconnect the manipulator body in half and remove the upper part.How to disassemble a mouse on, most of the questions do not arise, because the circuit board is usually no fixed, but in some models it can be screwed small cogs, so you need to be careful.If the board can not be removed, it is necessary to loosen all the fasteners.
mouse can be attached and snap to their definitions need to pass through the joint halves with a screwdriver and open them.When disassembling the manipulator is important to remember exactly how the items are arranged to the right and then collect them back.Do not touch the optical prism and other optical elements.If, however, a touch could not be avoided, it is necessary to wipe away the traces of dirty cloth with a special liquid to clean the optical parts.
Many users question arises, how to disassemble a mouse, if it is wireless.First you need to turn off the laptop or computer.Cordless Mouse for Notebooks understand practically the same as wired.In the center of the manipulator is a silver button, it is necessary to press, remove the cover and remove the AA batteries.
Jewelry screwdriver unscrew all fastening.You must also get rid of the rubber base on the bottom of the cover.This can be done with the help of nail files.Mouse should be divided into two parts.At the bottom of the board is located, scroll wheel and an antenna.To get the card, you need to unscrew the four bolts.After that, the mouse is fully ready for inspection and repair.
