If, until recently, were the best of friends homebody sofa and TV, but today this role goes to the computer.But more honorable status "do not pour water" is applicable to the outgoing duo "man and laptop."
Almost all modern technology has a sufficiently high degree of strength.It is no exception and a laptop.Despite all endowed with the quality of the manufacturer, the portable computer is not protected by many of the situations that could damage it.If the mechanical protection will display a special protective film laptop, how to stretch the life of the product as a whole?
From that protect the laptop?
first and most common risk - coffee, tea, or other beverages.Hit them in the computer may cause a short circuit.As a consequence, fails keyboard adapter and motherboard on which it is mounted.Repair damaged so products will cost slightly less than the cost of a new laptop.However, all may end up even worse if in the case of closure will be damaged and other components.There is more than unpleasant consequences: not only have to buy a new computer, and restore the data on your hard drive.
no less dangerous for the laptop computer dust.Its action particles comparatively with the properties of the abrasive powder.They're getting into the unit, accelerate wear of mechanical parts.Moreover, dust accumulation may eventually affect the operation of the keyboard.
is no less protection and care needs of the portable screen assistant, which eventually covered all sorts of exploitation and scrapes.Such minor damage can significantly affect the quality of the image.Known reliable, affordable way - a special film that allows you to save the appearance of the product for a long time.
How stick protective film?Step by step instructions
Before you stick a protective film, you must wash your hands thoroughly to avoid fat prints on the screen.This is followed by a special cloth to clean the screen, eliminating him from lint and dust particles.
Pulling out of the packaging film must be carefully separate her replication layer a couple of centimeters.Sticky part attached to the top edge of the display, and then gradually separating unnecessary layer, cover the entire surface of its screen.To the protective film on the screen is flat and without air bubbles, it is necessary to accompany the process of sticking smoothing using plastic cards or other devices.
Perhaps the film from the first lie is wrong.In this case, it can be carefully peeled off and started again.How to stick the protective film again if it landed small villi?To this end, it should be washed under water and blow dry.Quality film does not lose its adhesive properties.However, the absence of the protective layer is much harder to sticking.
How stick protective film when wet?Of course, this process requires more patience.Moisten film under running water and shaking applied it to the surface of the screen.Then use a plastic card "banishes" out of her remaining air and moisture that gets wet in parallel with a dry cloth.It is important to avoid moisture inside the device!
