Very often the people who are in the personal possession of the cottages, gardens, faced with the need to care for your lawn in the area.In such cases, simply can not do without the usual manual or braid trim.Start slowly fades into the background, and the people who use it, it becomes less and less.Trimmer also runs automatically and does not require much effort.Especially since the presence of special skills to use it is not necessary.
How does the trimmer?
principle of operation of this device is that mows grass a special line was installed on the rapidly rotating head.The number of revolutions per minute can reach 8000. For a short time the fishing line becomes unfit for use, or rather erased.Then truckers question arises: "How to fill in the line reel trimmer"?
Types of woods trimmer
First of all, not to resort to frequent changes, it is better to use a heavier fishing line.The number of categories and manufacturers simply amazing.The main parameter of line trimmer is its diameter.It ranges from 1.6 to 3.2 mm.The most common type is a 2-mm monofilament.However, it is necessary to make the selection depending on the type of your existing trim.
There are several options section of line.Thus, it can be round, square, star-shaped with a sharp-edged.The most effective is the last option.However, its use is only powerful queues and it is necessary to know how to fill in the line reel trimmer.Consequently, it can be concluded that the more powerful your brushcutter, the monofilament should be thicker.
This process is winding fishing line on the trimmer is not complicated, but it has its own peculiarities.First we need to find the right line, the diameter of which is registered in the passport of the device.
To begin, remove the spool cap.Be careful, because the thread may be left, and right.Left-hand thread needed to during the spit head does not spin.
Filling in fishing line trimmer
Before you fill the line to trim coil, measure from the roll of 5 m (fishing line so the average is set to trimmers).Then fold it exactly in half, in order to find the middle ground.The resulting center must be inserted in a special slot, which is located on the coil.After that, make a winding fishing line in the direction of the arrow, which is available on the head.
There are models in which the place of winding is divided into two halves.Therefore, one often wound in a clockwise direction, and the second - against.The fishing line is wound completely, its ends are threaded into the holes.Top cap worn on the head.
follows from the above that the process of replacing the fishing line is not complicated.After such manipulation as winding fishing line onto the spool trimmer, several times, you would bring this process to automatism.The only thing you need to constantly monitor the state of the fishing line in order to avoid rupture at work at the site where the spare coil on hand may not be.
Now you know how to fill in the line reel trimmer and will be able to do it yourself without much effort!
