laminate floors have one major advantage over the others: they can be laid on the surface of any material.However, this coating to impart strength and avoiding its deformation with time, it is necessary to make a pre-alignment of the floor.Now before you there is a question as to align the floor?When aligning under the laminate you will be required special precision.
To align the floor, and that this requires
most smooth surface can be obtained through the creation of concrete ties, which can only be done in homes with strong beams of concrete or wood.In this case, floor leveling procedure is performed in two stages.If you are concerned with the question of how to align under a laminate floor, you should know that now the most effective is not an ordinary concrete screed and a special self-leveling flooring compounds samorazravnivayuschihsya.In the first stage, the so-called rough alignment.The main screed thickness consists of mixtures krupnofraktsionnymi particles.Finishing alignment is usually performed using a small fraction of mixtures that are applied as thin layer, creating almost entirely smooth and even surface.
If you have to talk about how to align the floor, it is worth noting that at the preliminary stage must be carefully prepare the surface, that is, clean it from the weak and peeling concrete, carpet glue and cement, oil and other residues of the previous coverage.If you do it well enough or do not do, the new coating can be with air bubbles inside, and the clutch mixtures with a basis to be strong enough.To get the most was the smooth surface is required to set the level, and when the beacons are installed, it is possible to start to pour the foundation.To prevent leaks, a foundation should pave the waterproofing.The final alignment can be started only after the rough layer is completely dry.Since the consistency of finish solution sufficiently liquid, it will be spread evenly across the floor, creating a smooth and very smooth surface.When the coating dries completely, you can begin installing laminate flooring is strong will, will not have voids and depressions.
How to align the wooden floor under the laminate
There are times when it is not possible to remove the old flooring to lay laminate.To remove the discarded wood floor joists and everything is very time-consuming process.You can make the alignment of the floor for laying laminate, but it is associated with certain difficulties.In certain areas of the wooden floor board in time may sag, while others may bulge.The problem can not be solved in full through sanding the floor, that's why before laying laminate flooring must be put a plywood or particle board, which are placed under the insulation to improve thermal insulation.However, sheets of plywood, too, can sag, and to avoid this, it is necessary to ensure a robust system of supports in the form of frequent lag and strong.Once the screws are installed in the form of a lighthouse, you need to install the joists, which then fix the leveling material.This technology leveling floors raises their level of only two to three centimeters.Before you laid laminate on plywood or particle board, it is required to lay a substrate made of cork or polyethylene foam.Laminate is almost the most popular material for flooring, it can serve for many years, if it is laid on a flat, smooth surface.
As you can see, the issue of how to align the floor, there is nothing to worry about.There are some very simple ways to do it, not spending a lot of time and effort.
