most difficult areas of repair in most cases are the bathroom and kitchen.It takes a lot of expensive materials and time to conduct the full range of necessary work.
In addition, newcomers often have questions about how to wipe the seams on the tile as on the accuracy of this operation depends largely on an attractive aesthetic appearance of the room.
What should be done before starting work
Keep in mind, hurry before this important event, it is not necessary.Fresh tile should "take a strong liking" to the wall at least a week.Yes, modern varieties of adhesive allow grout already on the fifth day, but it's still better to wait a little longer.And especially do not do it the next day after laying.This, incidentally, are famous for many "shabashniki."
We clean
Before you wipe the seams on the tile, you should carefully clean up the edges.Maximum gently remove dried glue pieces, remove the dirt and the entire collection of fingerprints.Doing it more convenient with a sharp knife stationery, immediately removing the dirt with a vacuum cleaner.After that, the seams carefully with a soft sponge.
Cooking grout
Follow the instructions on the package, prepare the mixture.In most cases the composition per kilogram of grout take about 300 ml of water.
To do this takes a sufficient amount of capacity, it is filled with water and mix with a wooden stick until a funnel.It mixture is poured in a thin stream.Knead until you need, as long as it will not get a good density of sour cream.Then five minutes leave her alone, and then again interfere.
work!
Since wipe the seams on the tile you need maximum accuracy, use a rubber spatula.Surplus erase the edges, again pushing the joints.When they are completely full, remove excess material once again, moving to the next job site.If you are doing this for the first time, it is better to try your hand on a small section of the wall.
We wait about 20 minutes, then proceed to zamyvke.By the way, before you wipe the seams on the tile, make sure you buy enough of soft sponges for washing dishes, because they needed many times!
Wet and thoroughly wrung out one of them, gently wash off the remnants of the mixture with a trowel seams.It is very important not to rush, and as carefully as possible pressing the sponge, as otherwise the water will be dried on a hot plate to form a stunning pattern.
So we learned how to be overwritten and the joints between the tiles.Many workers in this stop, but we will go to the bitter end, making their job perfectly!
Shaping seams
To do this, pick up a small piece of a hose from a dropper or something like that will fit perfectly into the seam.Pushing the selected tool into it, you build up a perfect picture of all joints in the tile.This work is more tedious, but the result is extremely beautiful!
By the way, how much wipe the tiles?It all depends on your staff and your aesthetic preferences.For example, the cheapest is floating around a hundred rubles for a couple of kilos, while a kilo of ready mix may have cost up to five times higher.
