Do you often have to stand for long periods and click on the button remote control car alarm because it unusable, and you do not know how to turn off the alarm?Or you come from some place and you know that the car keys on the ground, but the key had disappeared.Of course, such situations do not happen so often, but it happens, and how to be in this case, try to understand.
In order to understand how to turn off the alarm, there are several options.Firstly, the glass can be broken so that the signal is not successful, or slightly lower, after which neatly clipped wire, which leads to the transmitter.Another way to turn off the alarm - is the use of electroshock.For this it is necessary to put several discharges to the glass so that they take effect at the transmitter, which is fixed on it.It is also possible to create interference noise, while using special tools.First learned of the frequency of the transmitter, and then it is subjected to noise levels.
How to disable the alarm without remote control, not everyone knows, so you should make out all the details.In the first step should be to disconnect the siren, so it does not annoy others.In the case where you have your car keys, you can open the hood, find the place where the siren itself, and cut the wires.Bell is filled with foam, but that's when the siren operates autonomously.If you do not have foam, you can use a hammer and hit hard, of course, I'm sorry, but what to do?But how to turn off the alarm, if no keys?To do this, look under the car, that is, to lie on the ground and find a tighter siren and broken wires, suitable for her.
When the first phase is finished, the audio signals will cease and will only lights flashing.Now start looking for the main unit alarm.It can be found on the precise clicks, which publishes the relay.In most cases, this procedure should be carried out on the car, where the injector or the immobilizer installed.One of the best options is to turn off the alarm in the car, is that you know exactly what an alarm system installed, or you have a printout which clearly defined colors and numbers of wires.
There are a variety of ways lock: it can be performed on a closed relay to open, bus-based LAN, or even it is embedded.In the first case, we can simply break the wire, thereby de-energize the relay.In the second ground must be one of the wires, to put this jumper.The next type of lock can be removed peremknuv two wires that go into the unit.
on cars with carburetors, you can not even look for the location of the lock, in order to start the car, you need to connect the positive terminal of the battery and the ignition coil.On diesel engines with solenoid valves need to connect the positive terminal of the battery and the output valve on the pump.Thus it turns out that in order to start the engine, you just need to apply voltage to the wire retractor relay.
your alarm off, bon voyage!
