Recently, light elements, such as tape, is often used for tuning cars.They are used to illuminate the disk bottom, interior of the vehicle.About how to connect the LED strips in a car, auto technical workers know perfectly well, but if you choose to act on its own, you should read the following useful information.Immediately, we note that an important plus tapes LED - is that they are prepared as much as possible in order to carry out their own installation.Moreover, they not only look impressive, but they are also cost-effective, extremely durable (employs about 5000 hours) and made of waterproof material.
Step 1. How to connect LED Strip: choose the place of installation and the length of the tape
The first thing to decide in which part of your machine you want to install the LED lights.Then you will need to determine the length of the tape that you need.Remember that this product can only be cut through multiple periods (eg Tape SMD 3528 Q60 is cut every five centimeters).When calculating the length of this must be considered.Also, you should know that the width of the strips with LEDs is less than two centimeters at a thickness of two millimeters, and the standard length of the tape in the reel - five meters.
Step 2. How to connect LED Strip: choose which tape
matter what place you have chosen for installation, and it depends on what you need to buy a tape.So, to illuminate the bottom of the use of waterproof LED strip material onto which a transparent coating of silicone.Such a tape can be chosen as a monochrome or multicolored, on which the LEDs of three colors.The latter option is very popular as a result of mixing these three colors tape can radiate any shade and color.
to illuminate under the hood, you will need to shrink LED ribbon.And in order to illuminate the bottom of the front seats in the car, you will need the tape with LED self-adhesive base.In general, LED Strip, due to its length and flexibility, it can be attached wherever your imagination allows.
Step 3. How to connect LED Strip: choose power supply
Based on the fact that the LED strip are different voltage (5, 12 or 24), you need to purchase the appropriate power supply unit tape.To do this it is best to consult a professional to minimize the risk of an unsuccessful purchase.
Step 4. How to connect the LED Strip: carry out the installation and connection of the tape
When you have acquired all the necessary items you have to prepare the selected surface-to-install LED strip.The place for installation should be carefully degreased (eg with alcohol).In general, it is best if the selected surface will be solid, that helps prevent damage to the tape of the PCB.In the case where you will be mounted on a metal surface or any other conductive, insulating tape.
If the tape does not need pruning, then immediately proceed to its installation.Using the adhesive layer, which has a back side LED strip is made very easy.After removing the protective cover, press the tape to the surface.
Now you need to connect the tape to the controller and power supply.This is done with the help of wires on the tape.Each entry has its own designation (G, B, V +, R) on the conductive path.Connect (according to the polarity) to the four inputs available on the controller with the same symbols (G, B, V +, R).
Now connect the power supply to the network (220) with two wires to the terminals N- and L +.Connect the "plus" on the block to the "plus" on the controller and "minus", respectively, to the "minus".The polarity of the voltage can not be confused in any case, as this may cause damage to the tape, and equipment damage.
Now you know how to connect LED strips in the car.And when you consider that today the purchase of such goods affordable for almost every owner of the car, do not hesitate to go to the nearest point of sale of automotive products or open the respective page of the online store.
and good luck on the road!
