Stabilizator - is an essential element of the suspension of each vehicle.And if while driving on rough roads iron your friend started to make strange noises in the area of the front wheel arches, it is said that the spare part has deteriorated.If you do not do the timely installation of the new parts, probably in a week you will need to also replace the stabilizer bushings.But it is possible that the spare fails with the rack.So do not ignore these signs of malfunction.
Tools
In order to produce high-quality substitute in the garage conditions, we need a set of tools.Before work should prepare a jack, a screwdriver, a set of wrenches, grease and a special spray WD-40 to remove the rust.
Car preparation
First we should install the machine on a flat, paved surface (possible best to call on a viewing hole).Then switch off the engine and put the car into gear.To be safe, apply the parking brake.And one more thing - if replacing racks stabilizer front, be sure to lock the rear wheel chock in front of the set belay support.Similarly done and with the C-pillar, only in reverse order.
phased replacement process
First we need to loosen the wheel, or to the reception so we never get.Remove using balonnika bolts and set aside part of the way.If nuts found rust, spray the area with WD-40.This drug will eliminate corrosion, thereby making it easier for us to work.Then unscrew one nut mounting racks on each side of the car.Disassemble the 2 bracket bolts that hold the rod and rod stabilizer bar.The bar from the racks to remove the fasteners.
Next, we need to take another tool.To replace racks of the stabilizer was successful at removing the mounting nuts can be used wooden hammer to remove the item from the stabilizer.If it's not, its function can replace metal counterparts, but beat on the details of it should be very easily and accurately.Then remove the rack and check it for deformation.When spare bent only slightly, it is permissible to align and set in place without buying a new one.If you can not restore the integrity of the previous parts, it is better to replace it.Air stabilizer desirable change.The same goes for worn bushings.
replacement racks stabilizer: the last stage
Now set everything in place.Nuts brackets should be wrapped to eliminate the gap in the cushions.Barbell rack with the new (or restored old) set up in its place.And in order to unscrew the bolts on their own are not while driving, lubricate them with grease.Install and remove the wheel chocks.Everything at this stage replacement racks stabilizer completed.
